Digitus professional DN-95115 User manual

8/16/24 - Port Gigabit PoE+ Injector
Manual
DN-95115 DN-95116 DN-95117
Introduction
The family of Power over Ethernet PSE (Power Sourcing Equipment) injects power
over data-carrying Ethernet cabling. It follows the IEEE802.3af/IEEE 802.3at and is
completely compatible with existing Ethernet switches and networked devices.
Features
8/16/24 channels Power Sourcing Equipment (PoE Injector)
Support 8 ports full load, max: 150W (DN-95115)
Support 16 ports full load, max: 250W (DN-95116)
Support 24 ports full load, max: 370W (DN-95117)
IEEE802.3af/IEEE802.3at compliance
Remote power feeding of Ethernet terminals up to 100 meters
Auto-detect of POE IEEE802.3af/IEEE 802.3at equipment
Independent overload and short-circuit protection per channel
LED indicators power input indication
Internal AC/DC converter – no need for external power brick
AC input 100~240VAC, 50/60Hz
Standard 1U, 19" rack mountable
Easy plug-and-play installation

Package Contents
Gigabit PoE injector
AC power cord
User’s manual
Four (4) back rubber feet
Two (2) rack-mount pallet and screws
Hardware Description
This Section mainly describes the hardware and gives a physical and functional
overview
DN-95115 Physical Dimension:
The physical dimension is: 275mm x 180mm x 44mm (L x W x H)
Front Panel:
The Front Panel consists of 8 x RJ-45 Ethernet ports (data), 8 x RJ-45 PoE ports (data +
power), and 8 x LED port indicators.
DN-95116 Physical Dimension:
The physical dimension is: 440mm x 200mm x 44mm (L x W x H)
Front Panel:
The Front Panel consists of 16 x RJ-45 Ethernet ports (data), 16 x RJ-45 PoE ports
(data + power), and 16 x LED port indicators.
DN-95117 Physical Dimension:
The physical dimension is: 440mm x 330mm x 44mm (L x W x H)
Front Panel:
The Front Panel consists of 24 x RJ-45 Ethernet ports (data), 24 x RJ-45 PoE ports
(data + power), and 24 x LED port indicators.

LED Indicators:
Ports On Power feeding
Off Unknown device attached, no power feeding
Rear Panel:
The AC inlet is located at the rear panel. The device will work with AC in the range
100~240VAC, 50/60Hz.
Technical Specification
Item Description
Model DN-95115 DN-95116 DN-95117
No. of
P
orts 8 16 24
Pass Through Data Rates 10/100/1000 Mbps
Power over Ethernet Output Pin Assignment and Polarity: 1/2 (-), 3/6 (+)
Output Power Voltage: 48~56Vdc
User Port Power: 30W
Power AC Input
V
oltage 100 to 240
V
AC
Power AC input Current 2.7A at 110
V
AC
3A at 110 VAC 4.5A at 110
V
AC
Power AC Frequency 50 to 60 Hz
To t a l
A
vailable Power 150W 250W 370W
Dimensions L x W x H (mm) 275 x 180 x 44 440 x 200 x 44 440 x 330 x 44
Indicators User Indicator: Channel Power
Connectors Shielded RJ-45, EIA 568A and 568B
Environmental Conditions Operating Ambient Temperature:
-10 to 45°C
Operating Humidity:
Maximum 90%, Non-condensing
Storage Temperature:-20 to 70°C
Storage Humidity:
Maximum 95%, Non-condensing
R
eliability MTBF: 100,000 hrs. @25°C
R
egulatory Compliance IEEE 802.3a
f
(PoE), IEEE 802.3at (PoE+)

Application
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the
requirements of Directive 2014/30/EU (EMC), Directive 2014/35/EU (LVD) and the Directive
2011/65/EU for RoHS compliance. The complete declaration of conformity can be requested
by post under the below mentioned manufacturer address.
Note:
If wrongly installed or improperly used in the living area, the device can cause interference in
radios and other electronic devices. Appropriate use is when the device, as far as feasible, is
operated with shielded connection cables (with network products in addition to category
5 shielded cables and higher). The device has been tested and falls within the limits of class A
computing equipment according to the requirements of EN 55032.
Warning:
This device conforms with test category A - it can cause radio interference in the living area;
in this case the operator may demand that appropriate measures are implemented and arise
for this reason. Declaration of conformity: The device fulfills the EMV requirements
according to EN 55032 for ITE and EN 55024 class A. In this way, the fundamental protection
requirements of the EMV-2014/30/EU guideline are fulfilled.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
PoE IP Camera
Data
Data + Power
PoE IP Camera
PoE IP Camera
PoE IP Camera