DOGIPOT DOGIPARK PLAYGROUND FOR DOGS 7731 User manual

DOGIPOT®TELESCOPING POST (ITEM 1301-P)
800.364.7681
www.DOGIPARK.com
PLAYGROUNDS FOR DOGS™
YOUR PLAYGROUNDS FOR DOGS DECORATIVE FIRE HYDRANT INCLUDES:
• 1 Red decorative re hydrant
• 4 Red powder coated in-ground mounting J-rods
FIRE HYDRANT (ITEM #7731)
SPECIFICATION AND INSTALLATION SHEET
INSTALLATION AND OPERATION INSTRUCTIONS
1 Find the desired location that is at and accessible on all sides for dogs to enjoy the Decorative DOGIPARK®Fire
Hydrant. It is recommended to remove any sod around the Fire Hydrant so that it can be installed on a at area
and surrounded by mulch.
2. Mark the location of the (4) four holes on the ground where the ground mount installation j-rods will be inserted into the
ground through the base of the re hydrant.
3. Use a broom stick, tomato, ground stake or similar items to pound into the ground to create 4 holes approximately 2-3”
wide and 14” deep for the j-rods to be inserted.
4. Lay the re hydrant on the ground sideways and slide each j-rod into each hole on the base of the re hydrant to prepare to
install into the ground.
5 Per the directions on the bag, pour some quick setting concrete into each hole lling them up.
6. Position the re hydrant in the installation area and slide the installed j-rods into each concrete-lled hole.
7. The j-rods may need to be swiveled back and forth gently to get them to slide all the way down into the wet concrete lled
holes If necessary, gently hammer the j-rods, into their holes. CAUTION: The powder coating on the top of the j-rods can
be chipped and damaged if the top of the j-rods are not covered with a soft item if hammered. Proceed slowly and tap
gently to ensure they are not damaged. The re hydrant will need to set and cure per the directions on the quick setting
concrete that was used.
8. It is recommended to surround the re hydrant with a wood mulch to create a buffer so the landscapers maintaining
the area do not hit the re hydrant with a lawnmower or weed trimmer and so that there is no grass immediately around it
that will be destroyed by the dog urine that likely will increase in the area due to the presence of the re hydrant.
9. The Decorative DOGIPARK® Fire Hydrant may also be surface mounted instead of ground mounting. Surface mounting
hardware has NOT be included and the j-rods will not be necessary for this type of installation. CAUTION: DO NOT
OVERTIGHTEN any surface mounting hardware. This may damage the base of the re hydrant.
WARNING: THIS IS A DECORATIVE FIRE HYDRANT TO ADD CHARACTER TO YOUR DOG PARK AND FOR DOGS TO ENJOY.
IT IS NOT DESIGNED FOR PEOPLE TO CLIMB OR STAND ON. THIS COULD DAMAGE THE FIRE HYDRANT AND INCREASE
THE CHANCE OF INJURY. DO NOT CLIMB, SIT, LEAN OR STAND ON THE FIRE HYDRANT AT ANY TIME.
PLEASE CHECK THE ABOVE INVENTORY AND CALL YOUR DISTRIBUTOR IF ANY PARTS ARE MISSING.

800.364.7681
www.DOGIPARK.com
PLAYGROUNDS FOR DOGS™
FIRE HYDRANT (ITEM #7731)
SPECIFICATION AND INSTALLATION SHEET
SAFETY WARNINGS AND EQUIPMENT MAINTENANCE RECOMMENDATIONS
PLEASE READ THESE IMPORTANT SAFETY WARNINGS AND KEEP ON FILE FOR FUTURE REFERENCE REGARDING INSPECTION REMINDERS •
AND LIST OF PARTS.
Follow installation instructions and nd a safe, suitable location for equipment use. •
All products should be in-ground or surface mounted and securely fastened to concrete. Concrete footers should never protrude above the ground where •
they are exposed and could create a safety hazard. Ground covering, such as mulch, is recommended over the buried footers and under an around the
equipment. •
Regular scheduled review of equipment should be conducted to ensure there is no existing damage caused by wear and tear, improper use or vandalism. •
All equipment should be free from rust or other structural damage. Replace or repair in the event any rust exists that could affect the structural integrity of •
the equipment.
Any areas where the coating has been removed should be repainted to deter rusting or other damage. •
Any protruding bolts, rough or sharp edges should be covered, capped or removed. Inspect for broken, bent or worn pieces and replace if present. •
Never add components not intended for this equipment. • EQUIPMENT IS NOT INTENDED FOR USE BY PEOPLE. THE EQUIPMENT IS SOLELY
INTENDED AND DESIGNED FOR DOG USE ONLY.
Proper and regular maintenance of equipment includes, but is not limited to, inspection of footings, all bolts and connection points, edges, landing areas, •
coatings and surfaces. This includes regular tightening of bolts, nuts and screws.
ANY WORN OR BROKEN PARTS, BOLTS, NUTS, SCREWS, INSTABILITY IN THE FOOTERS AND THE LIKE SHOULD BE REPLACED IMMEDIATELY TO •
PREVENT ANY INJURY.
WARRANTY
DOGIPOT® warrants to the original consumer purchaser that our DOGIPARK® brand products will be free from defects in material workmanship under
normal use for a period of two (2) years from the date of purchase when installed and maintained properly.
DOGIPOT® may elect to repair or replace any defective DOGIPARK® product covered by our warranty. Our warranty does not cover defects caused by
misuse, abuse, vandalism, negligence, alterations, environmental conditions, extreme weather conditions, manmade or natural disasters, lack of maintenance,
improper installation, storage or handling or normal wear and tear from use.
DOGIPOT® provides a limited warranty for the RUFFCOAT™ and Thermoplastic coated elements for 5 years.
Damages or loss in transit is the responsibility of the carrier, whether visible or concealed. It is the responsibility of the recipient to ensure that the order is
received both complete and without damages. Before signing receipt, inspect the shipment immediately and completely. Note any damages or shortages
on the bill of lading. Damage reports must be led within ten (10) days. DOGIPOT® is not responsible for lost damages or loss in transit. Title to all goods
passes to the customer at the time of shipment. DOGIPOT® will assist in ling claims if the freight arrangement was made by DOGIPOT® at your request.
Cancellations and returns are only accepted with the approval of DOGIPOT®. No equipment shall be returned without a Return Materials Authorization
which is issued by customer service. Any returned equipment must be returned in the original packaging and wrapped and stuffed to avoid damage, or in
a similar suitable condition. A restocking charge of up to 25% will be applied to all returned goods when the error is not that of DOGIPOT®. The customer
is responsible for all freight charges to return any equipment.
PRODUCT DETAILS:
• Made of unsaturated Poly Resin - so
it is light and durable
• Coated with Red Poly Urethane
Paint to seal out urine, dirt
and other natural surface enemies.
• 5 year warranty on coating
• Total Weight 29 lbs.