Linear Range - TV Scenarios
TV screens above the linear range of replaces can be achieved in a number of ways. It is largely not
recommended to position a TV directly above any of the Lopi linear replaces due to the large amount of
radiant and convection heat produced, however it can be achieved in a number of suggested ways.
Building a TV recess/niche directly above the replace is restricted by the minimum enclosure height of
each replace so as an alternative a number of proposed set-up options to protect the TV are shown below.
Scenario 1 - Double Recess
In this scenario a wall is built out from the face of the replace by 100mm in depth and the TV recess is
created within the built out section above the replace. This is achieved by using the minimum mantel
clearances shown in the installation manual of each replace.
Example shows the 4415 HO GS2
Dimensions of this example found on page 5
