DRONE SKY HOOK Ltd. www.droneskyhook.com
For Installation and Operation videos visit www.droneskyhook.com/product-support
Drone-Sky-Hook - ARROW
Professional Release & Drop device for DJI Phantom 4 / Phantom 3
Model numbers: DSH-SRD2-P4-3; DSH-DRD2-P4-3; DSH-SRDP2-P4-3; DSH-DRDP2-P4-3
Quick Installation Guide - DJI Phantom 3 (all models) v1.2
Slide the alignment pin bracket
from the drone’s inner side on
both rear landing gear
Turn the alignment pin bracket
towards the bottom side of the
landing gear until it locks
Verify that the alignment pin
bracket is in-line with the bottom
side of the landing gear
Align the Drone Sky Hook Arrow’s
hole with the alignment pin and
press down on the Arrow until it
locks to the landing gear
Press down the other side of the
Drone Sky Hook until it locks to the
landing gear
The locking pins should be fully
inserted
The LED Sensors is installed under
the front right electric motor
Slide the rubber band over the
motor and insert the pin to the
hole in the drone’s arm
The LED Sensor should fully cover
the drone’s lens
Fully insert the plug of the LED
Sensor cable into the ‘SENS’ port
on the Drone Sky Hook Arrow
