Enabling Technologies DYNAMIQUE Manual

[2]
Initial Assembly
Your Dynamique comes partially assembled. No tools are necessary to finish
assembly.
In one box will be your Frame, Seat, Footrest, Handle, Articulating
Mechanism, and any extra parts you ordered.
In another box will be your bi-skis.

DYNAMIQUE
[3]
1) Install the Bi-Skis to the
Articulating mechanism.
Align the feet of the Articulating
Mechanism behind the ski’s bindings.
Compress the retaining ring on the
front binding and slide the Ski
backwards onto the Articulating
Mechanism. Once fully in, the
retaining ring will snap into place
around the Articulating Mechanism’s
foot.
2) Install the Articulating
Mechanism to the Frame.
Place the lower frame within the
channels of the Articulating
Mechanism. Push two quick release
skewers into the ski from the right
side and secure with the thumb nut of
the other side. Clamp quick release
lever to secure the mechanism and
frame.

[4]
3) Set up the Seat.
See the image to the right for proper
setup.
The waist has two pads secured
with a ratcheting V-ladder.
The thigh has one pad secured
with a single ratcheting ladder
The seat angle adjustment has
two extension buckles at the
front of the thighs secured to two
single ratcheting ladders from the
seat back.
4) Remove and discard the
wooden dowels from the foot
and handle tubes.
The pin is not pinned through the
dowel. Remove the dowel first and
then remove the pin.
5) Install the Footrest.
Be careful to slide each side in
straight and at the same time. Slide /
tap the footrest into the tubes. If
necessary, a rubber mallet can be
used to overcome initial friction. If
necessary, tighten the ankle angle
adjustment clamps.
11) Install the handle.

DYNAMIQUE
[5]
