
EP-HWK SERIES OPERATION PROCEDURE
1. Make sure that the unit’s power cord is in good condition without any damage.
2. After unwrapping the product from its shipping box, plug the unit to the wall.
3. Clean the surface for debris, vacuum thoroughly before applying HWK to any surface.
4. Turn on the HWK using the power switch on the unit, and then hold HWK approximately ½ inch to
1inch from surface, and gradually move the HWK over the entire surface.
5. Try to allow the light on each area for 1-2 seconds to ensure optimum UV exposure.
6. The UVC can be used on majority of the surfaces such as: bedding, countertops, cash registeres,
touch screens, kitchen utensils, clothes, keyboards, telephone handsets, toys, desks, etc.
7. The closer the unit to the surface, the higher the disinfection rate.
MAINTENANCE:
Each HWK unit will have its own power control using a push-button switch located on the top side of the
unit. EPL products do NOT usually require periodic maintenance, but since the HWK units are operated at a
publicly accessible location – it is advisable to check for any vandalism, foreign debris, quality of the
protection mesh on the unit.
SERVICING:
EPL units contain no serviceable parts and require no adjustments. All EPL products are designed to provide
many years of air disinfection without any need for servicing. If the EPL unit does malfunction contact your
EPL sales representative to discuss obtaining a replacement unit.
EPL TECHNICAL SUPPORT:
techsupport@eplightinc.com
4220W 2100S, Suite N,
Salt Lake City, UT 84120
844.500.7436
eplightinc.com
uvkleen.us
----------------------End of the Document-----------------------