Equip 650374 User manual

50kgx3
110lbsx3
RATED
50"
MAX
200x200/300x300
400x200/400x400
600x400
INSTALLATION MANUAL
45"-50" Triple Screen
Ceiling Mount
650374

Required for Installation
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, contact your place of purchase for a replacement.
Component Checklist
mounting rail (x2)
A
collar (x3)
B
TV bracket (x6)
D
end cap (x2)
E
connecting bar
C
(x3)
•Use with products heavier than the rated weights indicated may result in instability causing
possible injury.
• Please closely follow the assembly instructions. Improper installation may result in damage
or serious personal injury.
• Safety gear and proper tools must be used. This product should only be installed by
professionals.
• This product is designed to be installed on concrete ceiling only.
• Make sure that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
• Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
• This product contains small items that could be a choking hazard if swallowed. Keep
these items away from children.
• This product is intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury.
CAUTION
have any questions regarding any of the instructions or warnings, please contact your
local distributor for assistance.
Read the entire instruction manual before you start installation and assembly. If you

Component Checklist
Package M x3
Package W x3
expansion bolt
W-A
(x6)
M6 (x12)
Q
locking piece (x6)
S
end cap (x3)
J
cable clip (x6)
K
sliding nut (x14)
L
pole (x3)
F
ceiling plate (x3)
G
end cap (x3)
H
end cap (x3)
I
M8x12 (x18)
M
M8x80 (x9)
N
M8 (x9)
P
D8 washer (x2)
R
Double Ended
Cresent Wrench (x1)
T
3mm Allen Key (x1)
U
mounting template (x1)
X
M8x10
O
(x2)
4mm Allen Key (x1)
V
5mm Allen Key (x1)
W
washers (x4)
M-F
small spacers (x8)
M-G
big spacers (x8)
M-H
M8x50
M-E
(x4)
M5x14
M-A
(x4) M6x14
M-B
(x4) M6x30
M-C
(x4) M8x30
M-D
(x4)

60mm
(2.4")
45mm
(1.8")
ø 12mm
(ø 1/2")
Drill pilot holes
2
Mark the
exact location of
mounting holes
1
1:1
GF
N
P
W
J
2. Attach Ceiling Plate to the Concrete Ceiling
1. Assemble the Pole
X
T
W-A
Insert the expansion bolts into the hole as shown.
Once inserted, remove the washers and hex nuts.
Attach the hex nuts to the expansion bolts corresponding
to the keyhole pattern found on the ceiling plate. Do not
overtighten and leave a small gap so the ceiling plate will
slide into the keyhole slots.

A
C
A
1:1
U
Q
3. Extend the Mounting Rail
T
WARNING
Installers must verify that the supporting surface will safely support the combined weight of the equipment
and all attached hardware and components.
X=1070mm X=1070mm

1:1
LM
B
W
L
E
R
O
X=1070mm
center
X=1070mm
4. Attach Collar to the Mounting Rail
·Keep the mounting direction of collars are the same.
·Ensure the gap between the collar halves on both sides are equal.
Note:
5. Install the End Cap

1:1
X X
√
1
W
1:1
W
N
P
T
6. Attach Mounting Rail to Pole
23
Once the rail has been determined, firmly
tighten the bottom rail to the mounting poles
as shown prior to mounting the displays.

M
W
0° -5°
-10° -15°
-20°,-15°,-10°,-5°,0°
D
1:1
8. AdjustmentTilt
7. Install the Plastic Cover
-20° is the natural angle and the safety pin is unnecessary.
Remove the CoverAttach the Cover
H
I

With the arrow pointing up
D
Top of the display
TV TV TV
M-A M-B
1:1
M-F
9. Attach TV Bracket
9a. Attach TV Bracket to Flat Back Screen
Position the adapter brackets as close as possible to the center of the display.

TV TV TV
1:1
M-C M-D
M-E M-F
M-G M-H
M-C
M-D
M-H
M-G
M-C
M-D
M-E
M-H
M-E
M-H
M-G
M-E
M-H
M-G
M-C
M-D
M-H
M-G
9b. Attach TV Bracket to Irregular Back Screen
Do not overtighten screws.
Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen.

X X
√
10. Hang the Screen
S
Note: Leave at least 1mm gap
between screens.
Note: Padlock is not included.
11. Secure with Padlock

13. Cable Management
V
1:1
12. Level Adjustment
K
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).