Ercol pero 2366 User manual

2366 pero low shelving unit
Than you for purchasing this pero shelving unit Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product
Pre-assembly preparation
Please ensure instructions are read in full before attempting to assemble this product
Necessary Tools
Please chec the pac contents before attempting to assemble this product. A full
chec list of components is given in this leaflet. If any components are missing, please contact the retailer
from whom you bought this product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
The fittings pac contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.
ercol

A
12 x M6 35mm olts
B
1 x allen key
C
8x rass shelf supports
D
1x Zinc and gold racket
E
2x 16 pan head screw
Fittings and parts c ecklist
Step by step assembly instructions
1. Lay the top of the unit on the floor. Making sure the shelf pin holes are facing inwards, use the
allen key provided to screw 3 of the olts into each of the legs at oth ends FINGER TIGHT
ONLY. When all 12 are in place tighten fully. Turn the shelving unit upright.
2. Push the shelf pins into the legs at desired heights and place the two shelves onto them.

Wall fixing - if in dou t seek professional advice
Wood
If fixing to wood
make sure that it
isn’t chip oard as
screws can easily pull
away from the core
structure
Brick or Masonry
Use an appropriate
wall plug provided you
are sure your wall is
sound
Cavity wall
Special toggle
wall plugs are
needed. Seek
expert advice
1. To attach the shelving unit to the wall, use the racket and 2 pan head screws provided.
Screw the long end of the racket to the ottom of the desk in the middle, using the pre drilled pilot
holes provided.
The shorter end of the racket should face downwards and e flush with the top edge of the unit.
2. If you don’t need to use Rawl plugs in your wall, push the unit to the wall and screw the unit to the
wall through the slot on the racket.
3. If you do require rawl plugs for your wall. Push the unit to the wall and mark the wall
where
the slot on the racket comes. Take the shelving unit away from the wall.
Using screws suitable for your type of wall, see Wall fixings a ove. Drill a hole within
your mark of the racket slot, add rawl plug, place the unit ack up against the wall and screw it into
your wall.
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buc s. HP27 9PX www.ercol.com
PLEASE REFER TO THE ERCOL CARE CARD ENCLOSED WITH YOUR FURNITURE.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE