Fanvil WB107 User manual

WB107
Wall Mount Bracket
Quick Installation Guide
www.fanvil.com

1. Package Contents
Wall Mount Bracket Quick Installation Guide
2. Physical specification
Model Size
WB107 162.55 x 121.83 x 41.7(mm)
3. Installation Diagram
1) Place the bracket in the position to be installed and mark the position of
the screw hole;
2) After removing the bracket, use an electric drill to drill the 2 holes at the marked.
3) Push or hammer screw anchors into the drilled holes, then insert 2 screws,
as shown below：
Screw position
22
TA4*25mm
Screw
WB107
Wall Mount Bracket
Quick Installation Guide
www.fanvil.com
Applicable models
V series IP Phone

3) Push or hammer screw anchors into the drilled holes, then insert 2 screws,
as shown below：
4) Insert the tabs on the wall mount bracket into the slots on the back of IP phone.
And then slide the wall mount bracket to right, as shown below:
5) Pull the hookswitch tab in the handset cradle and rotate the hookswitch tab 180
degrees, then reinsert the hookswitch tab, as shown below:
6) Finally, mount the IP phone to the wall, as shown below: