Button Functions
Turn on/off camera and
wifi
Press once, camera ON; Press and hold for 3
seconds to flip the image
Long press to switch four resolutions
Operating instructions:
Use the 5V power supply on the drone to supply power to the camera, then press the
power button to start the machine, and the buzzer will ring once. After power on, the
default resolution of the camera is 2.5k60fps (EIS on). If you want to switch the resolution,
long press the recording key to switch. The switching sequence is: 4k60fps(buzzer rings
once) /2.7k60fps 4:3 (buzzer rings twice) / 4k30fps 4:3 (buzzer rings three times ) /
2.5k60fps EIS on(buzzer rings four times). If the camera needs to be flipped 180 degrees
for installation, long press the power button for 3 seconds after turning on the camera,
and the camera will turn on the image flipping function. After the camera is turned on,
you can turn on the WiFi function by briefly pressing the power key, and then connect the
WiFi hotspot of the camera with your mobile phone (firefly_x_...) to connect with Firefly
app (the initial password of the app is 12345678). App can set camera time and
parameters, preview and download videos.
Description of buzzer sound:
After power on, if the card is not inserted or full, the camera will beep all the time; If there
is a plug-in card but no video recording, it will beep twice every 6 seconds to prompt the
pilot to record before taking off; A short press of the power key will sound once,
indicating that the WiFi function is on. Press it again, and sound twice, indicating that the
WiFi function is off. Long press the power key for 3 seconds, the buzzer rings three times,
indicating that the image flipping function is on. Long press for 3 seconds, the buzzer
rings four times, indicating that the image flipping function is off.
Four parameter adjustment methods:
1, The camera's own buttons are simple to adjust parameters;
2, Adjusting parameters through lite_config.txt document by computer;
3, Adjusting parameters through Firefly APP.
4, Through the parameter adjustment cable.
For more information or update the firmware, please visit the official website：
www.Hawkeyefpv.com.cn.
