Frontage CASSARA TEAK 20127A User manual

20127A - CASSARA TEAK CLUB CHAIR
F R O N T G A T E *
O U T F I T T I N G A M E R I C A ' S F I N E S T H O M E S
Page 1 of 3

20127A - CASSARA TEAK CLUB CHAIR
PART LIST :
HARDWARE :
Part #
QTY
Part #
QTY
A. BACK REST 1 PC H1 ALLEN HEAD BOLT M6X50mm 6 PCS
H2 WOODEN SCREW, 25mm 2 PCS
B SEAT 1 PC H3 WOODEN SCREW, 40mm 2 PCS
H4 WOODEN PLUG 4 PCS
C RIGHT END FRAME 1 PC
TOOLS NEEDED (INCLUDED) :
T1 ALLEN KEY (Included)
T2 PHILLIP HEAD SCREW DRIVER (Not Included)
D LEFT END FRAME 1 PC T3 GLUE PACKET (Included)
ASSEMBLY TIME :
APPROX 30 MINS
NUMBER OF PEOPLE TO INSTALL :
RECOMMENDED 1 to 2 Persons
PRE ASSEMBLY INSTRUCTIONS:
1 Do not throw away packaging materials until the assembly is complete. Part might be
accidentally thrown away.
ASSEMBLY INSTRUCTION :
STEP 1 :
1.a Lay the Right End Frame , (a sticker on the seat base is attached to differentiate the
2 end frames) on the floor facing up the holes, DETAIL 1. Use the packaging material
Description Description
F R O N T G A T E *
O U T F I T T I N G A M E R I C A ' S F I N E S T H O M E S
2 end frames) on the floor facing up the holes, DETAIL 1. Use the packaging material
the protect the End Frame against the floor. See Figure 1a
1.b Attached the 3pcs of Allen Head Bolt (H1) and tighten it with the Allen Key (T1), DETAIL 2
see Figure 1b
1.c Align the Left End Frame's mortise hole(D), to the tenon of the Seat (B) and Back Rest(A)
See Figure 1c, then follow step 1b
Sticker "RH"
C
A
B
Figure
1
b
Figure 1a Figure 1c
D
Sticker "LH"
DETAIL
1
DETAIL
2
H1
T1
Page 2 of 3

STEP 2:
2a Let the Club Chair stand on the floor. Press the End Frame (C, D) manually againts the
Backrest (A) until no gap on the connections. Attach the Wooden Screw 25mmL(H2)
on the upper part of the Endframe(C,D) by using a Phillip head Screw Driver (not included)
Detail 3, do the same on the other ends. On the middle part of the frame, attach the
Wooden Screw 40mmL(H3) and follow as per Detail 3
2b Apply a glue (T3) on the edge of the Wooden Plug (H4) by a hand brush (not included)
then insert it to the holes where the Wooden Screws (H2/H3) were installed, Detail 4
ASSEMBLY IS COMPLETE
20127A - CASSARA TEAK CLUB CHAIR
DETAIL
3
H2
H3
H2/3
H4
DETAIL
4
F R O N T G A T E *
O U T F I T T I N G A M E R I C A ' S F I N E S T H O M E S
T3
T2
CARE & MAINTENANCE
: Use mild detergent and water to clean. Store in dry, covered area
when not in use and at the end of the season. Occassionally check the nuts and bolts and re tighten if
needed.
Please contact one of Our Product Specialists for assembly assistence of questions at 1-800-537-8484
or email [e-mail]. Specialists are available weekdays 8:00 a.m. to 8:00 p.m. EST or
Saturday 9:30 a.m. to 6:00 p.m.
Page 3 of 3