GEPRC RAD VTX 5.8G 1.6W User manual

RAD VTX 5.8G 1.6W
User Manual

Specification:
Model: GEPRC RAD VTX 5.8G 1.6W
Inputvoltage: DC 7-36V(2-8S Battery)
Output: 5V@600mA(Power5Vtocamera)
Inputimpedance: 75Ω
Protocol: IRCTramp
Antennaconnector: MMCX connector
Cable connector: GH1.25-6P connector
Outputpower: 25mW/200mW/600mW/1600mW/Pit mode
Frequencytables: 40 CH/37 CH(FCC)/26CH(EU)
Videoformat: PAL / NTSC
Microphone: Built in microphone
Size: 36.5mmx36.5mmx5.5mm
Weight: 9.7g(withoutcable)
Mountingholes: 30.5mmX30.5mm(M3)

Features:
1. 1.6Wsuper-power,suitableforLongRangeflightwithgoodstability.
2. Fivepowerlevels:25mW/200mW/600mW/1600mW/Pit mode .
3. Two-layerboardcoolingstructure,separatepowerBECandmain-board,reduc-
ingandshieldingfromtheinsinalinterference.
4. Temperaturecontrolprotectionfunctionthatcanpreventhightemperature
burning.
5. Widevoltageinput,supports7V-36Vvoltageinput.
6. VTXcontrolprotocolisIRCTramp,supportsOSDparameteradjustment.
7. VTXbuiltinmicrophone,real-timereturnofDrone'ssounds.
8. Has3regionalfrequencytablestomeettheneedsofvariousregions.
9. Twofunctionbuttons,threeindicatorlights,easytooperate.
10. Mountingholesis30.5mmx30.5mm.

Introduction:
Pit-25-200-600-1600mW
BUTTON
Power indicator light
DC 7-36V
GND
GND
5V OUT
VIDEO
IRC
CH indicator light
Band indicator light
MMCX socket
AGC MIC
Both buttons have the same
function and are easy to operate

1. How to set Channel:
Press and hold for 3 seconds to enter the Channel Selection:
LED Color CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Flash 1X Flash 2X Flash 3X Flash 4X Flash 5X Flash 6X Flash 7X Flash 8X
Blue
2. How to set Band:
LED Color Band A Band B Band E Band F Band R
Flash 1X Flash 2X Flash 3X Flash 4X Flash 5X
Green
Press and hold for 3 seconds to enter the Band Selection:

WARNING:
1. Install antenna before use.
3. The 5V Output is just used for a Camera/Cooling Fan! Don’t connect
Power Input / Battery to 5V Output port. Otherwise the VTX will be
damaged.
3. How to set Power:
LED Color Pit 25mW 200mW 600mW 1600mW
Lignt ON Flash 1X Flash 2X Flash 3X Flash 4X
Red
Press and hold for 3 seconds to enter the Power Selection :
2.To prevent overheating, provide constant airfiow and a well ventilated
environment.Install a cooling fan if operating in confined conditions.

How to use IRC Tramp:
DC 7-36V
GND
GND
5V OUT
VIDEO
IRC
FC
UART-TX
F722
1. Connect the IRC Tramp port to the FC’s free UART-TX .
2. Open BetaFlight ,enter Ports tab,under perlpherals next to the UART-TX which
is connected to the IRC port of the VTX select IRC Tramp,save the settings.
IRC Tramp
Peripherals
AUTO
Disabled
AUTO
Disabled
AUTO
Disabled
AUTO
Disabled
Disabled
Blackbox logging
VTX (TBS SmartAudio)
VTX (IRC Tramp)
Camera (RunCam Protocol)
Benewake LIDAR
OSD (FrSky Protocol)

AIRMODE Permanently enable Airmode
On Screen Display
Dynamic gyro notch filtering
OSD
DYNAMIC_FILTER
Other Features
3. Enter configuraton tab,turn the OSD on under Other Features,save the settings.
4. Enter Video Transmitter tab ,Load from file ,save the settings.(The file can be
downloaded from the GEPRC website.)
Load from file
Table.json
5. Turn on the remote control,THR middle,YAW left,PITCH up,enter the OSD menu.
The PITCH moves the cursor up and down, and the ELE right to enter the next
item. Finally,save and exit.

5. Turn on the remote control,THR middle,YAW left,PITCH up,enter the OSD menu.
The PITCH moves the cursor up and down, and the ELE right to enter the next
item. Finally,save and exit.
Mode-2 Mode-1

- - MAIN - -
PROFILE
FC&FIRMWARE
FEATURES
MISC
SAVE / EXIT
OSD
- TRAMP -
X R7 5880 25
PIT OFF
( FREQ )
BAND RACE
5880
1
25
45
POWER
T ( C )
SET
BACK
CHAN
- - - FEATURES - - -
BLACKBOX
POWER
VTX
FAILSAFE
BACK
LED STRIP
CONFIRM
YES
NO
12
3 4

Frequency table:

PS:
1. All components has been strictly inspected and tested before shipping.
2. If you have any problems, please cooperate with our engineers to figure
out solutions. (E-mail: [email protected].)
Warranty Policy:
1. If VTX is damaged or unknow issue,please contact GEPRC. We'll do our best
to get this taken care of quickly for you.
2. Any impact damage, product liquid damage, high temperature burn or other
artificial damage is not covered by warranty.

Include:
1 x GEPRC ROS VTX 1.6W
1 x 5.8G Antenna MMCX 72mm
1 x MMCX connector to SMA connector 82cm
1 x GH 1.25-6P connector cables 150mm
1 x Matching screw package
Contact:
Website: http://geprc.com