GMI EL-200 User manual

EL-200 ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
Electric Hand Drill, 3/8" magnetic hex bit, 3/8" Crescent Wrench, Tape Measure.
BEFORE ASSEMBLING THE RACK
Read through the assembly instructions to familiarize yourself with the order in which the parts are assembled.
We suggest that you clear & vacuum the area where the bench is to be assembled.
It is important that the bench is assembled in the same sequence as instructed.
HARDWARE
All assembly hardware is provided. Floor Anchor hardware is not provided.
WARNING!
THIS RACK MUST
BE FLOOR
ANCHORED

6
5
9
8
7
4
3
33.5
32
8
7
Enlarged View of
Left & Right Uprights
1
11
10A
2
12
13
14
10B
10C
Double Holes
Double
Holes
# Qty. Description 12 Back Support Angle (95.25") 24 Back Support Angle (98") 31 Top Cap 41 Shelf A 51 Shelf B 61 Bottom Pan 73 Left Upright 81 Right Upright 91 Retainer Rail 10A 1 Top Shorts Panel (37.875") 10B 1 Middle Shorts Panel (28.625") 10C 1 Bottom Shorts Panel (29.875") 11 1 Shorts Shelf 12 1 Top Cap 2 13 1 Bottom Pan 2 14 1 Back Support

STEP 1
Identify components using the illustration above.
Caution - It is important to orient the back support angles (part #1) correctly.
Measure the distance from one end to the center of the third hole.
The distance from the top of the upright to the third hole is 33-1/2", from the
bottom to the third hole is 32".
All requried hardware will be 1/4-20 x 3/4" bolts and 1/4-20 lock nuts.
STEP 2
Lay the 98" Back support angles (2) down on the floor as shown below. Attach the back support (14) to the back side of
of the uprights. Next attach the bottom pan (13) and top cap (12) to the uprights. The bolts run up through the
angle & into the bottom pan (the nut will be
on the shelf side of the rack).
13
2
12
14
Bolt Direction
STEP 3
6
5
4
3
1
2
Bolt Direction
Place two 98" Back support angles (2) onto your partial assembly. Next set the 95.25” support
angles (1) in place on the 98” angles. Orient as shown in the photo. Starting at the top,
attach all pans to the angles as shown. Your bolts will run through both sets of angles and
the shelf.
CAUTION: orient the shelves exactly as shown above.
1/4-20 x 3/4”
Flange Head Bolt
Nylock Nut
Top Pan/Shelf Pictured
x72 x72

STEP 4
WARNING!
THIS RACK MUST
BE FLOOR
ANCHORED
STEP 5
Set (#10A-C) shorts panels onto
the shelves.
Attach the (3- #7 & 1- #8) left & right
uprights. The bottom of the
uprights have 2 holes, the tops
have just 1.
Run the bolt down through the
upright, into the shelves face.
8
7
Bottom
(2 holes)
Top
(1 hole)
Bolt Direction
10
Attach the (#9) retainer rail.
Bolts run through the retainer
rail, into the uprights.
Attach (#11) Short Shelf to
uprights (#8 & #7). Bolts run
through the uprights, into the
shelf
Bolt Direction
Bolt Direction
9
11