GMI GR Series User manual

GR SERIES METAL RACK
TOOLS REQUIRED FOR ASSEMBLY
1/2" Socket wrench & 1/2" Box end wrench.
BEFORE ASSEMBLING THE WORKBENCH
Read through the assembly instructions to familiarize yourself
with the order in which the parts are assembled. We suggest that
you clear & vacuum the area where the rack is to be assembled.
These instructions are intended as a general guide and may
differ depending on your application.
HARDWARE
All assembly hardware is provided.
FLOOR/WALL MOUNT HARDWARE NOT PROVIDED.
RACK BASICS
WARNING!
THIS RACK MUST
BE FLOOR
ANCHORED
Upright Assembly (x4)
Cross Brace (x2)
Side Brace (x4)
Shelf (Qty Varies by Model)
5/16-18 x 1/2”
Hex Head Bolt
Nylock Nut
(x20 per rack)
(x20 per rack)
Common hardware for all
bolting locations.

Bolt Direction
Side brace
under upright
STEP 1
Assemble as illustrated. Lay two uprights out and attach two side braces
between uprights using 4 bolts/nuts per side brace.
STEP 2
Stand up the uprights with assistance.
Attach cross braces to the backside
of the upright. Two bolts/nuts per cross
brace.
The position of the cross brace can be
mounted at three different heights to
avoid interfernce with the shelf, depending
on your desired shelf height. Use the
same height hole to attach the braces.
Use all upper holes, all center holes, or
all lower holes.
Bolt Direction

STEP 3
Insert shelf clips into uprights at desired
heights. Make sure clips are installed at
matching heights or shelf will not be
straight.
STEP 4
Starting at the top, place the shelves
onto the shelf clips. Racks will square
themselves as the shelves are
assembled. Lower shelves shouldn't
be assembled until rack has been floor
mounted.
WARNING!
THIS RACK MUST
BE FLOOR
ANCHORED