The MSR2000 adopts left-to-right air aisles.
Installing an Interface Card
SIC interface cards are not hot swappable. Only the MSR2003 router supports
DSICs.
!
If you remove the slot
divider between SIC slot 1
and slot 2, you can install a
DSIC interface card.
To install a SIC interface
card:
1. Remove the filler panel
from the SIC slot.
2. Insert the SIC interface
card.
3. Fasten the captive screws.
5
Installing the power module
Installing an Interface Card
AC power module
Before connecting the power ca
The AC power cord in the figu
MSR2004-48 supports two
power modules for
redundancy. The power
modules are hot swappable.
MSR2003/2004-24 use built-in
power modules.
ble, make sure the router is properly grounded.
re is only for illustration.
!
To connect the power cable when
1. Make sure the router is well gro
in the OFF position.
2.Connect one end of the power cab
source.
you mount the router on a workbench:
unded, and the power switch on the router is
le to the router and the other end to the power
6
DC power module
