HOMEGRID Outdoor Case User manual

OUTDOOR CASE INSTALLATION GUIDE
Outdoor Case Installaon Guide
1.
2.
4.
5.
Place the boom piece of the Outdoor Case on secure,
level ground that can support the weight of the baery.
Put the Stack’d Series base into posion on the boom
piece of the case.
Stack the baery modules on the baery base (2-4 module
stack). Add the BMS on top of the modules. The Stack’d
Series baery installaon manual can be found at
homegridenergy.com
3. Drill out holes on the back of the case that correspond to
the right stack height and conduit that you’ve chosen to
use. When drilling holes, make sure to leave room between
the holes for the waterproof conduit aachment.
Secure the back of the case to the base using two bolts at
the boom (make sure the rubber washers are used here).
Make all connecons through the conduit (finish baery
install).
Pass the Wi-Fi antenna through the included compression
fing at the top of the case.
OPTIONAL: Place bolts through the boom holes to
secure the enre stack to ground.

Outdoor Case Installaon Guide
6.
7.
Secure the front of the case and install all bolts/screws,
ensuring that rubber washers are used on every bolt.
NOTE: It is recommend for installers to put all the bolts
parally in place around the case before ghtening any bolt
fully.
OPTIONAL: Aach a lock through the front hole on the
boom of case.
OUTDOOR CASE INSTALLATION GUIDE