HYPERLOW VERT FREE V2 User manual

HYPERLOW VERT FREE V2: FRAME ASSEMBLY GUIDE
The following are frame assembly instructions for the 15mm kit. Your build experience may differ
slightly depending on your decision on whether or not to use the mounting shelves, or braces, or
smaller standoffs.
Assemble arms with 4 x 12mm bolts
Slot battery plate onto top plate with 6 nylon nuts acting as spacers and 4 x 20mm bolts and 2 x
12mm as shown. Make sure pressnuts are facing down  .

Using 4 x 8mm bolts, install 2 x 10mm standoffs up front along with TPU cam mounts, and 4 x
15mm standoffs as shown. The slide TPU shelves over standoffs and mounting bolts
Add 4 x 8mm to secure the front and rear bottom plate sections to the rear four standoffs.
Don’t tighten all the way yet.

Pay attention to arm orientation and slide them along with the 5mm carbon spacers into their
mounting areas. The carbon spacer MUST be underneath the front arms if installing the front
braces. Using 4 x 22mm bolts attach the arms and carbon locks to the body.
Insert middle section and secure with 4 x 22mm bolts.

With 2 x 12mm bolts sandwich the front brace arms and front bottom plate section between the
10mm standoffs and camera plate. Use 12-14mm bolts through the braces when installing motors.
Remove top 4 x 8mm bolts to install GoPro mount.