IcOtec GC300 User manual
Electronic Game Calls
GC300 Electronic Predator Call
Operating Instructions
Name: ___________________________________
Phone Number: ___________________________________
Street Address: ___________________________________
City: ___________________________________
State: ____________ Zip: ________________
Email Address: ___________________________________
Date of Purchase: ___________________________________
Place Purchased: ___________________________________
Serial Number: ___________________________________
Thank you for the purchase!
Please ll out your product registration information and mail it back to us within 15
days of your purchase date. Or, you may go to our web site to register your product.
Please retain your original receipt in the event that you would need to return the unit
for a warranty repair.
Failure to mail in your product registration card, or registering your product on our web
site within the 15 day period of the purchase will result in the voiding of the warranty.
1 YEAR LIMITED WARRANTY (Register within 15 days of purchase)
Your ICOtec product is warranted to be free of material defects and
workmanship for 1 year after the date of purchase. In the event of a defect
under this warranty, we will, at our option, repair or replace the product,
provided that you return the product postage prepaid. This warranty does
not cover damages caused by misuse, improper handling, installation,
or maintenance provided by someone other than an authorized service
contractor. Any return made under this warranty must be accompanied
by the items listed below:
1) A check/money order in the amount of $12.00 to cover the cost of
postage and handling
2) Name and address
3) An explanation of the defect
4) Proof of purchase with date of purchase
5) Product should be well packed in a sturdy shipping carton with
return postage prepaid to the address listed below:
Attn.: Repairs
ICOtec
6415 Angola Rd.
Holland, OH 43528
©2013 ICOtec. All rights reserved.
This warranty gives you specic legal rights.
Specications and product designs are
subject to change without prior notice or
obligation.
09/13
Serial # on label in battery compartment.
Mail to:
ICOtec
ATTN: Warranty Department
6415 Angola Road
Holland, OH 43528
Or, Log on to:
www.icotec.com
GC300 Electronic Predator Call
Warranty Registration Card
1Add Batteries
Open battery panel with phillip screw driver, place 4 new AA batteries
as indicated, close panel and replace screw. Lithium Ion
for best results in cold weather.
3Raise Antenna
Place antenna in upright position on main unit.
4Select Prey Call
Raise antenna on remote control and press button of desired call sound. All calls
cycle through a pattern of natural pauses.Your unit will play several seconds (30-40) and
then go silent (20-30) seconds and then play again indenitely until you select stop. This
is to eliminate the need for you to select stop and start several times per set.
5Adjust Volume
Press volume up arrow for louder or volume down arrow for quieter.
6Add Second Call
Press second desired call sound, both calls play until you select STOP.
7End Calls
Press STOP.
2Turn Power Switch On
Slide switch to the right, red LED indicator will light up if unit is on.
If it does not light up, open panel and be sure all batteries are new and in
proper position.
Setup & Operation Instructions
ICOtec GC300 Electronic Predator Call Check out more of our products at your
favorite retailer or online at icotec.com.
If your retailer does not yet carry our products, ask them to.
To nd a dealer near you, log on to icotec.com and select the Dealer List
ICOtec hats are coming soon!
Coyote Female
Coyote Howl
Coyote Male
Crow Baby Distress
Raccoon Baby Distress
Woodpecker Baby Distress
Bobcat Adult
Cottontail Distress
Coyote Pup Distress
Fawn Distress
Gray Fox Distress
Jack Rabbit Distress
Predator Calls (GC300)
Lost Your Remote?
For replacement remote or for an additional remote call 419-472-3300 x113 or email
your name, shipping address and phone number for a paypal invoice to be emailed
to you. Remotes are $25 plus $6.00 shipping.
Resynchronizing Remote to Unit
Your ICOtec remote can be reprogrammed to work with your base unit if it happens to become
unresponsive or if you lose your remote and purchase a new one form ICOtec.
Simply press and hold the reset button on the left of the “ON/OFF” switch of the base with a
paperclip, then press and hold any sound button on the remote unit for three seconds.
Note: Base unit must be playing a sound when the programming unit successfully.
Trouble Shooting
Unit does not play calls - Be sure batteries are NEW and are installed properly, if you
press a call button on the remote and the green LED light blinks, you need to replace
the 23A lithium battery in the remote. Remove the screw holding on the battery door,
remove, dispose of properly and replace as indicated.
To remove remote from unit, slide toward the rear of unit. Remote is very snug
the rst time you remove it, for better results hold unit against your body
speaker facing away and pull remote toward you.
Table of contents
Other IcOtec Hunting Equipment manuals
