11.14.14 02862H © Inovonics, 2014 - www.inovonics.com
ACC650 Enclosure
Installation Instructions
1 Overview
The ACC650 enclosure allows Inovonics EN5040-T and EN5040-20T high
power repeaters to be mounted in a UL approved outdoor enclosure.
1.1 Inovonics Wireless Contact Information
If you have any problems with this procedure, contact Inovonics Wireless
technical services:
• Phone: (800) 782-2709; (303) 939-9336
1.2 ACC650 Enclosure
Figure 1 ACC650 enclosure
2 Installation
2.1 Installation Notes
• These products are designed to be maintained by professional
security technicians
• All products should be manually tested weekly
2.2 What’s in the Carton
• One UL listed Type B 1/2” non-metallic liquid-tight connector
2.3 Install UL Listed Type B 1/2” Non-Metallic Liquid-
Tight Connector
To meet UL 2560 requirements and weatherproof the ACC650 enclosure, it
must be equipped with the included UL listed Type B 1/2” non-metallic
liquid-tight connector.
1. Use a Phillips screwdriver to loosen the four plastic housing cover
release screws.
2. Lift the cover off of the housing.
3. Drill a 13/16” (.8125”) diameter hole to accommodate the liquid tight
connector.
• If installing the liquid tight connector on the back of the ACC650
enclosure, use the drill target shown in Figure 2.
Figure 2 ACC650 enclosure back drill target
• If installing the liquid tight connector on the bottom of the ACC650
enclosure, drill the housing about 1.25” inches from the left side of the
enclosure, as shown in Figure 3, at a point halfway between the front
and back edges.
Figure 3 ACC650 enclosure bottom drill location
4. Remove all sharp edges from drilled hole.
5. Install the liquid tight connector into the drilled hole, ensuring the liquid-
tight gasket is in place.
6. Thread the included locknut onto the liquid tight connector on the inside
of the enclosure.
7. As desired, cut and fit UL listed Type-B 1/2” non-metallic liquid-tight
conduit to meet your cabling requirements
8. Mount the the ACC650 enclosure through either the mounting holes or
the mounting tabs.
9. Route cabling through the liquid tight connector and conduit and
connect to the repeater per the repeater’s installation instructions.
10. Insert the repeater in the repeater clip, as shown in Figure 4.
AHigh power repeater clip BMounting hole CMounting tab
1.25” from
the left
edge
In the middle of the
housing, roughly 1”
from the front or
back edge
