INS Global D5 Series User manual

Version 2.1
INSTALLATION GUIDE
D5
Reader output
Power requirements
Current consumption
Normal (@12V)
Activated (@12V)
Read range
Operating Temperature
Relative Humidity
Status LED’s
Audible tone
Keypad
RS485
+9Vdc to +24Vdc
123mA
132mA
Specifications
Information contained in this document is subject to change without notice
void the user’s authority to operate this equipment.
Introduction to INS D5
Thank you for purchasing an INS D5 Series Mifare Contactless
Smart Card & Keypad Reader.
The Keypad will output Cotag 4422 format. It can be custom
Wiring methods shall be in accordance with National Electrical
Code, ANSI/NFPA70.
Discharge the body of static electricity before wiring the unit
1. Connect the 0V (GND).
2. Connect the other Required cables apart from 12Vdc.
3. Attach the 12Vdc wire last.
Warranty
The D5 Series reader comes with a 1 year warranty from the date
of dispatch from INS Global. The warranty is void if the installation
instructions contained with this manual have not been adhered to.
28mm
121mm
85mm
Any changes or modications not approved by INS Global could

1. Insert four (4) screws (not included) into holes 2. Hook reader onto base. 3. Attach reader to base with base screws (included)
Placing the reader
General Wiring Schematic
Function Cable Colour
The 0V reference cable shall be included withing the controller cable.
The 12Vdc power cable shall NOT be included in the controller cable.
Only one power source is connected to the reader at any time.
LED line is low activated
NOTE
50
DRILLING TEMPLATE
SCALE 1:1
DIMENSIONS IN MMS 60
RS485A
RS485B
BLUE
VIOLET