Step 3. Cabinet or Wall Opening
The openingshould be perdimensions described below, All cot-__
nets shouldbe square. The floorof the opening must be plywood
and mustbe level and capableof supporting80 Ibs.
I
I1( "A II ii, I
_-\_ _-_ _ Installation Above Lower Oven
Note 1: When installing this Kit abovea built-inoven, checkbuilt-
in oven installation instructionsto determine cutout di-
mensions for the(lower) wall oven.
Note 2: For a new installation, the 48"height dimension to the
bottom ofthe cutout for themicrowaveoven is recom-
mended. This places the microwaveoven bottomat
Step 4, Assembly of Trim approximately 50" fromthe floor.Seefigure 6.
A. Locate pieces of assembly as indicatedin Fig. 5. These include
a top, bottom, right, left, (2) glass assemblies, 6 screws ('4 flat
head and 2truss head), and 4 end caps.
B. Insert end caps intothe endof thetop (see Fig.3).
C. Assembleouter frame by attaching top, sides, and bottom with
4 fiatheadscrews as depicted in Fig. 5.
D. Attachglass assemblies on leftandrightsidesby insertingflange
intotop and attaching with truss head screw in the bottom (see
":ig. 5). Outside of glass should beflush with outside trim.
fEndCaps
Notct_ _attop(L&SideR)_ -- I_11-._l_tl_ AssemblyGlassTopr--I"161/,,'_'-, _' SeeNote1__
Fig.3
"J"BottomFig.6
Step 5. Installation of Microwave Oven
A. Plugpower cord of oven intoreceptacle. MK27 Kits may be used with microwave model M169, installed
B. Slidetheoven intothe opening. Besure the lipofthe bottomrail aboveJenn-Air 27" wall oven models bearing manufacturer No.
isflushwith frontof cabinet. Center microwave in opening. E33658, when installed in accordance with Manufacturer's In-
C. Attach railto cabinet with 2 flat head screws (see Fig. 4). stallation Instructions.These include models W27100, W27200,
D. Attach trimassembly as shown in Fig.5. Insert bottomoftrimW27400.
assembly intorailand rotateupward.Attach top of trimtocabi-
net with 2 flat head screws. MK30 Kits may be used with microwave model M169, installed
__ above Jenn-Air 30" wall oven models bearing manufacturer No.
E33658, when installed in accordance with Manufacturer's In-
stallation instructions. These include models W30100, W30400.
Fig.4 Manufacturer's No. can be obtained from the serial plate on the
wall oven. - IMPORTANT-
--,,__ SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE
Part#210"777B
