Kammok Outpost Manual

Table of Contents
Outpost
Vehicle-Mounted Hammock Stand Setup Instructions
Designed in Austin, Texas | Made in China
Outpost Mount Setup...................................................................................................................Page 2
Outpost Setup...............................................................................................................................Page 3
Parts Included
Outpost Frame x1 Ball Hitch Mount x1
What You’ll Need
#4 Allen Wrench
#5 Allen Wrench
Clamp Mounting
Plates x2
Hammock
Straps x2
Hardware
Pack x1

WARNING: Max Weight Capacity 350 Lbs. USE HAMMOCK STAND WITH CAUTION. INHERENT RISKS EXIST. Do not modify the
stand or hammock in any way; modification may result in failure or injury and will void your lifetime warranty.
Outpost: Setup Instructions Page 2
Outpost Mount Setup
Mount one of the clamp
plates to the ball hitch
assembly using two of
the nylock nuts and flush
head bolts.
1
Setting up the Outpost Mount
Horizontal T-Slot Mount Setup
Slide two T-slot nuts into your desired position
in the T-slot channel.
Slide two T-slot nuts into your desired
position in the T-slot channel.
Vertical T-Slot Mount Setup
1
Position the ball hitch assembly over the T-slot nuts.
Bolt securely in place using two of the hex head bolts.
2Position the ball hitch assembly over the T-slot nuts.
Bolt securely in place using two of the hex head bolts.
2
1
Insert the 4 longer hex
head bolts through the
bottom of the other
clamp plate, and position
the mount assembly on
your rack/crossbars.
*Make sure all bolts are securely
fastened to ensure the safety of
this product.
2

Outpost: Setup Instructions Page 3
Outpost Setup
Remove your Outpost
from the bag.
Attach the middle section of the structural ridgeline.
1 4
5
Setting up the Outpost
Telescope the legs to the approximate desired height by
pressing the top of the release lever.
3
With the “A” frame legs resting on the ground, lift
the receiver end of the structural ridgeline and drop
it onto the ball hitch mount.
6
Press the spring pin buttons on the main pivot joint in, one at
a time, to deploy the legs into the open and locked position.
2
Attach the ball receiver section of the structural ridgeline.
WARNING: Max Weight Capacity 350 Lbs. USE HAMMOCK STAND WITH CAUTION. INHERENT RISKS EXIST. Do not modify the
stand or hammock in any way; modification may result in failure or injury and will void your lifetime warranty.

Outpost: Setup Instructions Page 4
Install the “U” shaped lock pin to secure the
Outpost to the mount.
1
Loop the one of the included straps through
the hole on the hitch receiver.
2
Loop the other included strap through the strap bar
on the main pivot joint.
3
Connect both straps to your hammock and enjoy!
4