Karat MK-KF-D200 User manual
(Installation Manual)
MK-KF-D200
-
(Multipurpose mouth filter automatic
open-close type Using power from batteries)
: Working system
- :
Multipurpose mouth filter automatic open-close type
Before use Sensor aerator please ensure that faucet is open
status
When the hand is near the sensor’s distance the water will
flow automatically
When the hand is near the sensor’s distance no.2 the water
will shut down automatically
: Inspection and advice before installation
Please consult the manual before installation and follow the installation instructions. To help extend the
lifespan of the product
Should not disassemble the faucet or equipment. Since the factory has specified a suitable installation
distance
Removing and installing various devices. Use a thick cloth to wrench. To prevent scratches.
AAA
Please check if the two AAA alkaline batteries meet the international Standard. Please note the anode and
cathode of the batteries when pit in the batteries
All the drawings are only for reference, please subject to the real product
: Packing list
1. Sensor (Sensor nozzle)
2. M24*1 (M24*1 Connector)
: Installation steps
1 : Steps 1
( A-1)
Turn off the faucet and take off the aerator (Pic. A-1)
: Steps 2
(A-2)
Choose the correct male/female water inlet connector and match its corresponding sealing gasket
(Pic. A-2)
: Steps 3
(A-3)
Set the locknut into the faucet and tighten the water inlet connector (Pic. A-3)
: Steps 4
(A-4)
Install the sensor onto the water inlet connector with its sensor facing front, tighten screwing the locknut
and then tighten screwing the sensor (Pic. A-4)
: Battery replacement
เมื่อแบตเตอร์รี่ใกล้หมด ไฟแสดงสัญลักษณ์จะกระพริบเตือนเพื่อให้เปลี่ยนแบต
When batteries drain out, the indicator light will flash to remind battery replacement.
When batteries drain out, the solenoid valve will be shut off automatically
: Steps 1
Press the battery case button on the battery cover as per the arrow indicates, the batteries will pop-up
: Steps 2
2
Install the new two AAA alkaline batteries
: Product features
: Convenient: water flows and stops by the sensor.
Hygienic: no need to touch the faucet and the handle to prevent bacteria cross-inflection
Water saving: water flows when the hand is approaching the sensor for first time and tops when the hand
approaching the sensor for the second time, which saves water effectively.
AAA-
Battery energy saving: with AAA battery can last 2-3 years without replacement
: Troubleshooting
: No water
: Battery drain
: Use new Battery
: Sensor
window is dirty
: Remove the dirty
: No water supply
: Wait for water
:
Blocking by dirty filter
: Clean the
filter
:
Water flows even it is
switched
: Dirty filter
: Clean the
filter
: Too little
water flow
: Dirty filter
: Clean the
filter
: Short battery life
: Standard new batteries used
AAA : Use
AAA alkaline batteries
: No
sensing
: Batteries drain out
: Change batteries
: Wrong batteries
firection
: Re-put batteries
: Cautions
Clean with wet soft cloth
Don’t shake the products
Don’t use strong acid or alkali detergent
: Instructions and Maintenance
:
Cleaning the filter gasket : before cleaning filter gasket, turn off faucet handle. Unscrew the locknut, take out
the gasket, wash it clean and install it back
: Function of product
:
Automatic wash : the infrared sensor opens and closed automatically
With the sensor on the side, water flows when the hand is approaching the sensor for the first time and
water stops when the hand approaching the sensor for the second time
Specification ) -
KP-01-555-11
: working water pressure
0.05~0.7 : 0.05~0.7Mpa
: Sensing distance
10±2 : 10±2cm
: Scan time
0.128 : 0.128 Seconds
: The longest washing periode
180 : 180 Seconds
: Installation diameter (water
inlet connnector)
M24*1, M22*1 :
Male MM24*1, Female M22*1
: Product size
76*60*92.5 : 76*60*92.5 mm.
: Power suuply
2 AAA :
2 AAA alkaline batteries (User supply)
, ,
–
–
–
–, *
, *
1. ,
-
2. ,
,
, ,
3.
4. , ,
:
