Kokot AP 400 User manual

Company: P.P.H.U. Andrzej Kokot
adress: Częstochowska 47A, Jaskr w
42-244 Mst w
tel./fax: [phone]
mobile: [phone]
www: www.kokot.com.pl
email: [email protected]om.pl
OPERATING AND MANUAL INSTRUCTION
(START-UP AND TECHNICAL SPECIFICATIONS )
AUTOMATING WASHING MACHINE OF SMOKE - DRIED STICKS
TYPE AP 400
APPLICATION: AUTOMATING WASHING MACHINE AP 400 is desi ned for cyklic washin
smoke-dried sticks made-up by stainless steel .
Description date : 9 Au ust 2006

______________________________________________________________________________
Thank you for purchase our equipment. Procedure according to his instruction
provide long-standing work your device.
YOUR SATISFACTION WILL BE FOR US
YOUR SATISFACTION WILL BE FOR US THE GREATEST REWARD. THE GREATEST REWARD.
______________________________________________________________________________
TECHNICALITIES
Proportions (width X len th X hei ht) : 800x1600x1500 mm Wei ht: 300 k
Operatin capacity : 120 l Max. operatin pressure: 300 kPa
Time fillin washin machine water: 8 min Power en ine: 0,37 kW
Warmin up with cardinal wash t=45 min Power tension: 380 V
Rinse: I t=9 min Heater power: 6 kW
Rinse II t=9 min
MASCHINE INSTALLATION
CONNECTION TO WATER MAINS SYSTEM
1. Washin machine should llenar water from water mains system on parameters in accordance with
workin standard.
2. If pressure will be inferior than 200 kPa (2 bar) dynamic pressure ,then in order to ri ht runnin
should be pump installed.
3. If pressure In water mains system is hi hest than 500 kPa (5 bar), then should install pressure reducer.
Washing machine can be connection to water mains system only by qualified and
authorized personnel .
CONNECTION TO GRID
1. Connection washin machine to rid must be made-up accordin to technical bindin .
2. Should make sure that wirin become ri htly round.
3. Washin machine recommend connect to rid throu h receptacle with Power switch mounted on the
all of facilities in accessible place.
4. Recommend to rid have protection In Power switch fire-fi htin form .
5. Volta e rid should match 230/400 +/ - 5%. Connectin phases should cause drum turn accordin
with clockwise.
Washing machine can be connection to grid only by qualified and authorized personnel .

MACHINE EXSPLOITATION
1. Turn on device after Wri ht connect to rid, mains water system and sewera e consist to load smoke-
dried sticks up to 2/3 drum diameter (about 300-400 smoke-dried stainless sticks) and ti ht close
cover.
2. Next should to turn knob of reset switch in position APPEND and Press on central button.
At this moment li ht up reen lamp indicate the be innin of washin machine work.
3. Washin machine take water until reach task level. At this time follow deter ent allowance and
en ine enclose yration of drum in the direction accordin with clockwise. Enclosin heaters si nal red
lamp.
4. After reach by bath temp.45°C heaters are turn off ( red lamp stop sine ).
5. At the end of washin sticks follow enclose pump branch unclean water .Automatic water intake and
drum move ive the be innin first rinsin . The number of rinse (1-2) is re ulate dependin on wash
quality.
6. Error of washin -machine work is si nal by pulsatin reen li ht.
7. Press the emer ency safety swich brin to a standstill drum and swich on pump pour out water from
washin -machine.
8. Time to pour water take about 2,5 min.
9. After this action can safe open cover ( without fear pour out water)
10. After end of work recommend leavin reset enclosure in position SWITCH
11. Enclose emer ency switch permit to break pro ram.
12. Re-enclose pro ram must be precede unblockin emer ency safety switch and reset main switch.
13. Multiplicity of clean filter depend to smoke-dried sticks cleanliness.
OPERATOR WORK SITE
The person who attendant AUTOMATIC WASHING-MACHINE AP400 should have easy access to
control buttons and head cover . In front of head cover should leave min.1,5m free space in order to
assurance easy open and close cover durin load/unload smoke-dried sticks.
CLEANING
Next to end of work AUTOMATIC WASHING MACHINE AP400 should completely core out from
washed smoke-dried sticks and expose to rinse . On this order should enact follows activities :
1. Take out and clear down filter which located strai ht below washin -machine drum.
2. Open head cover and stron stream water rinse out interior of washin machine , pay attention for
elimination of all pollution resultant wash smoke-dried sticks.
3. Install down filter and close head cover washin machine.
4. Put In motion washin machine In course basic wash. In this course washin machine take water
to ether with deter ent and execute rinse washin .
5. The time of rinse washin is 5min.
6. After 5 min press emer ency button. Pump inpump water from washin machine.
7. After 3 min open washin machine.

SERVICE, CONSERVATION AND REPAIRS
Basic condition ri ht exploitation AUTOMATIC WASHING MACHINE AP400 is sanitation inside of
drum .Number of pollution in result wash smoke-dried sticks have direct influence to pump efficiency
water from washin machine. In order to take washin machine in sanitation should keep rules definite
in point CLEANING present instruction .
SERVICE AND GUARANTED REPAIRS
Every complaints concernin action AUTOMATIC WASHING MACHINE AP 400should submit to
producer In writin ,fax or e-mail.
Guaranted conditions have been defined in WARRANTY enclose to present instruction.
SECURITY RULES AND BHP
1. Present instruction should keep hard upon washin machine , to be constantly accessible for service.
2. If device becomin sale or deliver someone else user , should make sure that present instruction is
located in complete with machine – to new user be informed about every limitations and method
machine service.
3. Washin machine can be attend only by adults.
4. Forbidden is work washin machine with: kids, woman in pre nant , ill person take a chemicals,
person after drink alcohol and person takin substances limited capacity concentration .
5. Connection washin machine to water mains system and rid can be done only by qualified and
authorized technical staff .
6. Minimal temperature of conditions durin washin machine work must have +5 °C.
7. Washin machine shouldn’t been mounted on electric cable or water supply and sewer pipe, device
le s should stay ri ht re ulate.
8. Before accession to clean inside washin machine should wait abort 2,5min. for switch off device
( time water issue from washin machine).
9. Is raw forbidden put In hands to device or touch part of container durin work or immediately after
end operatin .
10. Durin work device must not open the doors of washin machine.
11. Liquid remains must not let out to open water or biolo ical sewa e treatment .Should at this keep
current Rescript Minister of A riculture and Alimentary from day : 10.01.1991 in case security and
hy iene of work connected with treatment chemicals in a riculture
12. Person who is workin by washin machine should strictly comply to recommendations which are on
deter ent packa in .
13. Unacceptable is washin machine work with any leak.
14. Should accurately wash washin machine after every use and before performance service activities.
15. Self-willed chan es introduced to washin machine and usin her incompatibly with predestination
can lead to dama e washin machine or dan erous accidents.
16. For dama e resultin from non-observance rules enclosed in present maintenance instruction bear
responsibility only user .

WARRANTY CERTIFICATE - GUARANTED CONDITIONS
1. Person who order be obli atory in relation to delivered article have obli ation immediate exploration
article and lod e a complaint
2. Guarantee period is 1year and be in when a reement object will be borne to person who order.
3. Producer don’t bear responsibility for dama es , which arise as a result of wron or unprofessional,
mistaken installation in respect of start by person who order or another , natural consumption , wron or
careless service , use wron merformance materials or materials for replacements .
4. Person who order should, after a reement with seller, define suitable time and opportunity for
possible repair or procurement for him new pieces
5. Seller is obli ate to repair or replacement dama e piece to finish within the time until 4 weeks since
date of application .
6. Certainly not another demands , especially claim for dama e in result not on the same object of
transactions , unless if due deliberately or as a result of exceptionally ascendin ne lect .