Labo K Effects Warm Lady User manual

Labo ★K Effects – www.labo-k-effects.com – [e-mail]

Labo ★K Effects – www.labo-k-effects.com – [e-mail]
2
Contents
CONTENTS 2
TECHNICAL INFO 3
OVERVIEW 4
CONTROLS 5
POWER SUPPLY 6
POWER-LINK SYSTEM 7
ADVICES 9
TROUBLESHOOTING 10
RECALL SHEET 11

Labo ★K Effects – www.labo-k-effects.com – [e-mail]
3
technical info
COntrols
!Output level (Volume)
!Tone (Tone)
!Distortion amount (Drive)
TECHNOLOGy
!Selected components
!Robust diecast enclosure
!Cliff et Lumberg connectors
specifications
!True Bypass 3PDT switch.
!Consumption 4mA.
!Power: 9V battery or AC adapter DC 9V (not included).
!Dimensions : 4.7 (W) x 3.7 (D) x 1.6 (H)
!Weight: 13.05 Once.
Use quality mono Jacks cords only.

Labo ★K Effects – www.labo-k-effects.com – [e-mail]
4
overview
Warm Lady is to be classified in the family of Boosters / distortions.
She allows to obtain the sound of lamps overheated by an amplier.
The tuning of tonality is effective. Inserted into the chaine of the pedals of
effects her can also act as booster by respecting the grain of the guitar.
The Warm Lady will give body to your sound even at low level.
Like all Labo ★K Effects pedals, the Warm Lady is True By Pass. It means
that when the effect is not active, the device is completely disconnected from the
path of the signal and thus adds none résistive load in this one (The accumulation
of résistives loads on the path of the signal eventually decreases the power and the
brightness of the sound)
Optionals accessories
Power-Link cord by Labo ★K Effects
Allows to chain the supply of several
pedals from a single power supply using
the specific cord. (supplied with each
Warm Lady)
Knobs for Labo ★K Effects pedals.

Labo ★K Effects – www.labo-k-effects.com – [e-mail]
5
controls
I – THE POTENTIOMETERS
1. Volume
This control adjusts the output level of the Warm Lady.
2. Tone
The tone control acts on the frequency range of the signal.
3. Drive
This setting controls the amount of distortion.