Labtex LBT-M6D User manual

Operation instructions
1
AATCC SERISE
AATCC Dryer machine
Model:LBT-M6D
Operation instructions

Operation instructions
2
1/Objective: to use the washing machine properly and correctly
2/Suitable for Laboratory Using
3/Reference standard：
AATCC TM88B、AATCC TM88C、AATCC 124、AATCC 135、AATCC 143、AATCC
150、AATCC LP1-2018
4/Use methods and steps：
1Man-machine interactive console
2、Time Setting:
1) By manual knob, drying time can be
selected according to the demand.
Time decreases to the left and
increases to the right. Generally,
the initial default is 70 minutes
drying time.
2)
Choose the appropriate time
according to the demand before drying
clothes.

Operation instructions
3
3、Drying Procedure Setting：
1) The left knob of the panel is to select the drying procedure. There are three
procedures: NO Heat (no heating mode), Delicate (low temperature mode) and
Normal/Permanent press (high temperature mode).
2) The right side of the panel is the display interface of the drying program.
3) The drying mode corresponding to the setting of the process knob will be displayed
on the display screen.
The drying operation begins:
1) When the drying operation begins, the drying mode and time should be set first.
2) Put the object to be dried into the barrel and press the key .The dryer will
run automatically and the green working indicator will be on.
3) When the drying operation is completed, the equipment will stop automatically, and

Operation instructions
4
the red light working instruction will be turned on.
4) If you need to stop halfway, you can press the start button and the dryer will stop
running.
5) If you need to cancel the whole program, press about three seconds, then the
operation page of the dryer will return to the main page, and then proceed with the
selection of the program.
6) The standard program Delicate (low temperature mode), Normal/Permanent press (high
temperature mode), has 10 minutes of cold air drying time. When the confirmation
program runs, the display page will be added 10 minutes of time to display, while the NO
Heat file will be displayed according to the adjusted actual time.