Control and Operation
Remote control operation
Pick up the remote control, open the battery cover behind the remote control, and
insert four No. 5 batteries into it. Be careful not to reverse the positive and negative
poles, and install the battery cover. On the front of the remote control, push all the
top switches forward to reset them. Hold down the power button with one finger in
each hand for 2 seconds, and the remote control screen will light up and a power
on prompt sound will sound. The remote control is turned on. When turning off the
computer, use one finger with each hand and press the power switch for about 3
seconds. The remote control will sound a beep, and then the screen will turn off.
After the drone reaches the launch airspace, the pitch angle of the cigarette
dispenser is controlled by pushing or pulling down the right joystick of the remote
control, observing the first perspective image returned by the camera, aiming at
the target, and the direction axis needs to be aligned. The drone pilot needs to
adjust the drone's heading.
After confirming the alignment with the target, pull down the launch switch, the
electronic igniter will work, ignite the ammunition in position 1, and then fire the
ammunition. Pull back the launch switch, pull down again, and fire the ammunition
in position 2, and so on, fire 8 ammunition.
When launching each round of ammunition, the recoil force will lead to the change
of the pitch angle of the cigarette dispenser. The operator needs to use the remote
control to control the compensation angle and aim at the target.
VIDEO INSTALLATION TUTORIAL
