ledlenser ML6 Connect WL User manual

P6R Core/P7R Core
ML6 Connect WL
+1x +1x +1x +1x
+1x
OFF
OFF
White Red White blink Red blink
≤5sec≤5sec
+1x >5sec>5sec
OFF
>1sec
hold
Factory Setting
>1sec
hold
>2sec
hold
OR
18650
1.
2.
3.
+－
Power
Low Power Mid Power
1x
Click
Click
+1x
Power Low PowerMid Power
1x +1x
White
Red
hold
hold
2x
Blink=100%
Blink=10%
Power
10%→100%
100%→10%
Low Power
Low Power
Boost
>1 min
2x
≤0.5sec
≤0.5sec
White
Red
OFF
RedYellowGreen
!
Magnetic Charge System
Blink
!
5V
Red Green
OFF
>1sec
hold

ML6 Connect WL
Ledlenser GmbH & Co. KG
Kronenstr. 5-7 • 42699 Solingen • Germany
Phone [phone] Fax [phone]
[e-mail]
ML6 Connect WL_V.01
15.06.2020 1J12A0360
ledlenser.com
Remote ControlTransportation Lock
Battery Indicator
Battery Replacement
1x
Ledlenser
Connect App
Remote Control Menu
+
=
=
=
1x
Remote
control
>10%
Green
<10%
Red
1. 2.
3.
4.
OFF
ON
Ledlenser
Connect
+
Ledlenser
Connect
App
Boost
Tactical
Strobe
Select
Special
Function
App
>8sec
hold
2x Red blink
Factory Setting
2x
≤0.5sec
OFF 4x Red blink
4x Red blink
2x
≤0.5sec
>1sec
hold
>1sec
hold
+
+
+＝
+－
>1sec
hold
This device complies with Part 15 of the FCC Rules. Operation is subject to the followinng
two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B
digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to providede
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not
installed and used in accordance with the instructions,may cause harmful interference
to radio communications.However,there is no guarantee that interference will not accorr
in a particular installation.if this equipmemt does cause harmful interference to radio
or television reception,which can be determined by turning the equipment off and on,the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an autlet on a circuit different from that to which the
receiver is connectec.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The devicecan be used in portable exposure condition without restriction.