LEISUREWIZE Airbreak Infinity User manual

Airbreak Infinity
READ THE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND INSTALLATION
LWA56
Assembly instructions:
1 Ensure the ground is free of stones and other sharp
objects. Unpack and familiarise yourself with the
Airbreak, laying the Airbreak out flat on the ground
before inflation.
2 The Airbreak is comprised of three panels fastened
by zips. To inflate unscrew each securing cap of the
valve and insert the foot pump hose, and using the
foot pump begin inflation and fill until all the beams
are firm. Replace the securing cap on each valve and
tighten until you hear an audible click.
3 Once you are happy with inflation, position the
Airbreak as required and peg out using the eyelets
along the base of the Airbreak Infinity.
Airbreak (x3 panels) 1 - 480cm x 140cm (total)
Airbreak Peg Bag 1 Bag with 18 pegs
Foot Pump 1
Airbreak carry-bag 1
BEFORE USE
When you first receive your Airbreak check the following
is included to avoid inconvenience when fitting.

Additional Panels
The Airbreak can be expanded using additional panels (sold separately). These are available from your supplier
(Part No. LWA57).
Dismantling
To dismantle the Airbreak Infinity, simply reverse the erection procedure. The beams must be fully deflated and the
Airbreak Infinity should be completley dry prior to being carefully rolled and placed back in the carry-bag.
Beam leakages
Should you experience beam failure, at any point these are easily replaceable, replacements are available from
your original supplier.
EU Registered address: Ace Supply Co (Europe) Ltd. 25 Herbert Place, Dublin 2, D02 A098, ROI.
For product support:
E: suppor[email protected]
T: [phone]
For trade enquiries:
E: [email protected]
T: [phone]
Streetwize:
Ashburton Road West, Trafford Park,
Manchester M17 1RY
www.streetwizeaccessories.com
4 Finally ensure all of the guy ropes are pegged out
using the remaining pegs as this will give
the required stability to the Airbreak. Periodically
check the guy ropes and adjust if necessary.
Also check air beams and if required inflate until
firm again.