LEW ELECTRIC PUSH DOWN AIR SWITCH User manual

Installation Instruction Details
Rated Voltage: 110V ~ 220V
Application scope：Use together
Directions：
。
Introduction
123
Push Button
Mounting Surface
Push Button
Power Box
Main Power
Power Box
Plug
Push Button
Waste Processor Power Box
Main Power
Plug
Waste Processor
Push Button
Machine will operate
after finishing installation and pushing
the button. When waste cleared, push
the button again to stop it.
Attention:Make sure that air pipe is in place and choose proper power. To avoid electric shock,please don’t operate with wet hands.
with waste processor.
PUSH DOWN AIR SWITCH (PDAS)
Lock Nut
Air Hose
Gasket
Cut out a 1 3/8 inch hole on the
surface. Drop the push button in the
hole and hand tighten lock nut until
the push button is secure to the
surface.
Prod uct Na me
PDAS-XX (XX IS COLOR)
Connect the air hose to the push button.
To do this, unscrew the nut from the bottom of
push button, run air hose through the bottom of
nut, attach air hose to bottom of push button
and then screw nut back onto bottom of push
button. ,
Plug thepower boxinto an approved
GFCIreceptacle or a standard
duplex recetacle that is on a GFCI
curcuit breaker.

Push Button
Power Box（Front）Power Box（Side）
Lock Nut Gasket
Product DimensionDetails
PRIOR TO INSTALLATION
• Contact a local electrical inspector to make sure that this product meets or exceeds all
local electrical codes (electric codes may vary by location).
• Disconnect and turn off all power sources.
• Only licensed, insured, and bonded electrical contractors should install the PDAS.
• Lew Electric accepts no responsibility if the above conditions are not followed.
** CONTROLLER WILL WORK WITH WASTE DISPOSALS UP TO 1HP **
** PDAS CAN ACCOMMODATE A HOLE SIZE UP TO 1.5 INCHES**