Logik LGHOBX12 Parts list manual

4 Burner Gas Hob
Instruction / Installation Manual
LGHOBX12
LGHOBX12_IB_120601_Annie(Check).indd 1 12年6月1日 下午5:14

LGHOBX12_IB_120601_Annie(Check).indd 2 12年6月1日 下午5:14

Contents
Unpacking..................................................................................................................................... 4
Product Overview......................................................................................................................... 5
The Main Unit.............................................................................................................................................................5
Control Panel..............................................................................................................................................................5
Before Using Your New Hob......................................................................................................... 6
Lighting the Hob........................................................................................................................... 6
Flame Failure Safety Feature ....................................................................................................... 7
If the Burner Does Not Light........................................................................................................ 7
If the Flame is Irregular ................................................................................................................ 7
Electricity Failure.......................................................................................................................... 7
Cookware Guidelines ................................................................................................................... 8
Cleaning and Maintenance.......................................................................................................... 9
Cleaning the Gas Hob................................................................................................................... 9
Burner Parts and Pan Supports ................................................................................................. 10
Replacing the Burners................................................................................................................ 10
Hob Controls ............................................................................................................................... 10
Hints and Tips ............................................................................................................................. 11
Specications.............................................................................................................................. 12
Burner Values.............................................................................................................................. 12
Installation .................................................................................................................................. 13
Wiring .......................................................................................................................................... 13
Ventilation Requirements.......................................................................................................... 14
Gas Installation........................................................................................................................... 14
Installation and Service Regulations ........................................................................................ 14
Location....................................................................................................................................... 15
When the Hob is First Installed.................................................................................................. 16
Gas Connection........................................................................................................................... 16
Cut Out Dimensions ................................................................................................................... 17
Product Overall Dimensions..............................................................................................................................17
Fitting the Hob into the Worktop ............................................................................................. 17
Check the Hob After Installation & Before Using.......................................................................................17
Pressure Testing ..................................................................................................................................................... 17
Conversion from NG to LPG or from LPG to NG........................................................................ 18
Natural Gas...............................................................................................................................................................18
LP Gas ........................................................................................................................................................................ 18
Method......................................................................................................................................................................18
To Adjust the Gas Rate ............................................................................................................... 18
Minimum Setting or Turn Down................................................................................................ 19
Burner Conguration ................................................................................................................. 19
Safety Warnings.......................................................................................................................... 20
LGHOBX12_IB_120601_Annie(Check).indd 3 12年6月1日 下午5:14

4
Main Unit
Unpacking
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to local
regulations.
The following items are included:
Pan Support (Left/Right) × 2
P.N.: 37016688 (Left/Right)
LPG Replacement Rating
Plate Sticker × 1
P.N.: 20628175
100 mm Burner Ring × 1
P.N.: 37001476
100 mm Burner Cap × 1
P.N.: 37001479
75 mm Burner Ring × 2
P.N.: 37001477
75 mm Burner Cap × 2
P.N.: 37001480
55 mm Burner Ring × 1
P.N.: 37001478
55 mm Burner Cap × 1
P.N.: 37001481
Instruction / Installation
Manual
P.N.: 52068804
LPG Nozzle Installation Guide × 1
P.N.: 52007667
LPG Conversion Kit:
Fixing Plate × 4
P.N.: 37001970
Screw × 4
P.N.: 37002652
LPG Nozzle × 4
P.N.: Ø 85 37016927
Ø 65 37001483
Ø 50 37001484
Seal × 1
P.N.: 62000705
Thank you on the purchase of your new Logik 4 Burner Gas Hob.
You must read this manual in order to fully understand how to operate it correctly.
This unit MUST be installed by a competent and registered engineer (Gas Safe in the UK).
Please allow the installer to view the installation section of this manual.
Read all the safety warnings carefully before use and keep this manual for future reference.
If items are missing or damaged please contact Partmaster (UK only).
Tel: [phone] for assistance.
* All images are for indication only; please refer to your individual unit for actual item.
LGHOBX12_IB_120601_Annie(Check).indd 4 12年6月1日 下午5:14

5
Product Overview
The Main Unit
Control Panel
1. Standard Burner (75 mm)
2. Control Panel
3. Large Burner (100 mm)
4. Small Burner (55 mm)
To select upper right burner
To select upper left burner
To select lower left burner
To select lower right burner
1
1
2
4
3
* All images are for indication only; please refer to your individual unit for actual item.
LGHOBX12_IB_120601_Annie(Check).indd 5 12年6月1日 下午5:14

6
Lighting the Hob
1. Choose the control for the burner you want to use.
2. Press and hold the Burner control in and then turn it anti-
clockwise to the large flame symbol . The spark ignition will
operate whilst you hold in the control.
Continue to hold the control in for approximately 10 seconds
after the burner has lit. Releasing the control too soon will
extinguish the flame due to the flame failure safety feature.
Manual Ignition (in case of electricity failure)
To ignite one of the burners, press and turn the control counter-clockwise so that the control is at the
position. Hold an ignition source (e.g. candle lighter) close to the upper circumference of the burner.
Move the ignition source away as soon as you see a stable flame. Continue holding the control in for
approximately 10 seconds after the burner has lit. Releasing the control too soon will extinguish the flame
due to the flame failure safety feature.
3. Adjust the flame anywhere between the and positions. Do not adjust the flame between the and Off
position.
4. After ignition, check the flames visually. If you see yellow tipped, lifted or unstable flames; turn the control
off, and check the assembly of the burner rings and caps. Allow these to cool before touching. Also, make
sure that no liquid has entered into the burner cups. If the burner flames go out accidentally, turn the
burners off, and do not try to light them again for at least 90 seconds (to allow the gas to disperse).
5. When turning the hob off, turn the control in a clockwise direction. If the control stops at the maximum
flame mark, push the control in slightly and continue turning clockwise to the off mark, ‘O’.
Before Using Your New Hob
Before using your new hob, please:
• Read this manual fully taking special note of the ‘Safety Warnings’ section.
• Plug the hob into the electricity supply and turn it on so that the ignition circuit will work.
O
High
Low
• If the burner does not light within 15 seconds, turn the control off and wait for at least 90 seconds
before trying again.
• To switch the burner off, turn the control clockwise to the off position.
• After use, always turn the controls to the off position.
This appliance is for cooking purposes only. It must not be used for other purposes, e.g. room
heating.
• This appliance is for cooking purposes only. It must not be used for other purposes, for example
room heating.
• The use of a gas cooking appliance results in the production of heat, moisture and products of
combustion in the room in which it is installed. Ensure that the kitchen is well ventilated especially
when the appliance is in use: keep natural ventilation holes open or install a mechanical ventilation
device (mechanical extractor hood). Prolonged intensive use of the appliance may call for
additional ventilation, e.g. opening of a window, or more effective ventilation, e.g. increasing the
level of mechanical ventilation where present.
* All images are for indication only; please refer to your individual unit for actual item.
LGHOBX12_IB_120601_Annie(Check).indd 6 12年6月1日 下午5:14

7
Electricity Failure
If there is an electricity failure, you can still use your hob. Light the burners by holding an ignition source (e.g.
candle lighter) close to the side of the burner and turning the control to the High position to light the gas. The
controls must still be held down for 5 – 10 seconds after the burner has lit. Releasing the controls too soon will
extinguish the flame. Adjust the controls as required.
Flame Failure Safety Feature
The flame supervision device (FSD) probe cuts off the gas supply to the burner if the flame is extinguished.
When lighting the burner, hold down the control for approximately 5 – 10 seconds after the burner has lit.
Releasing the control too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least 90
seconds (to allow the gas to disperse).
If the Burner Does Not Light
If the burner does not light, check that:
• The hob is connected to the electrical supply and the supply is switched on.
• The gas is turned on.
• You have held down the control for at least 5 – 10 seconds after the flame has been lit.
• The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them gently with a
small nylon brush such as a toothbrush as shown below. Ensure the electrical supply has been disconnected
before cleaning.
If the Flame is Irregular
If the flame is yellow or irregular, check that the burner parts, including the burner cap (allow to cool before
touching), are:
• Clean and dry.
• Positioned correctly. See ‘Replacing the Burners’.
• Also see ‘Hints and Tips’.
Ignitor
Flame failure
probe
Burner Cap
Electrode Burner Ring
To avoid damage to
the ignition circuit
NEVER light the hob
when the burners are
not in place.
* All images are for indication only; please refer to your individual unit for actual item.
LGHOBX12_IB_120601_Annie(Check).indd 7 12年6月1日 下午5:14

8
• Do not use large saucepans or frying pans that overlap the edges of your hob as this can deflect heat onto
your worktop and damage the surface, and may also cause a hazard.
• Always make sure saucepans are stable. Using very heavy saucepans may bend the trivet/pan support or
deflect the flame.
• Always lift the cookware when removing from the hob, do not drag.
• When you need to boil, simmer or fry food, first set the temperature to the High position.
Once the food is boiling, reduce the temperature to maintain a steady heat to cook your food thoroughly.
Doing this will reduce the cooking time and save energy.
• Pan sizes should be as per the table shown below.
Burners Minimum Diameter Maximum Diameter
Large (100mm) 22 cm 26 cm
Standard (75mm) 14 cm 22 cm
Small (55 mm) 12 cm 18 cm
Cookware Guidelines
To get the best out of your hob, follow these simple suggestions:
• Use saucepans with thick flat bottoms. Food in a saucepan with an uneven bottom will take longer to cook.
• Using a lid will reduce cooking times and save energy.
• When liquid comes to a boil, reduce the temperature setting to maintain the desired level of boiling.
• Choose cookware of the proper size, material and construction.
• Minimise the amount of liquid or fat to reduce cooking times.
• Select the proper temperature setting for the cooking task.
Do not use cooking vessels on the hob that overlap its edges.
* All images are for indication only; please refer to your individual unit for actual item.
LGHOBX12_IB_120601_Annie(Check).indd 8 12年6月1日 下午5:14

9
Cleaning and Maintenance
Cooking Part Cleaning Important
Trivets/pan supports,
burner caps and enamel
surfaces
• Hot soapy water and nylon scourer.
• Mild abrasive cream cleaners.
• Fume-free or heavy-duty oven cleaners
(follow manufacturer’s instructions).
• Always allow hob parts to cool
completely before cleaning them.
• Always apply minimal pressure with
abrasive cleaners.
• Remove spills as soon as the hob is
cool to avoid the spills becoming
burnt on.
Burner parts • Hot soapy water.
• To clear the holes use a stiff nylon
brush.
• Mild abrasive cream cleaners.
• Ensure burner parts are dry before
refitting.
• Reassemble the burner parts correctly.
Controls • Hot soapy water and a soft cloth. • Care must be taken if removing the
controls from the shafts.
• If cleaning the controls whilst they are
attached to the shaft, ensure liquid
does not enter the appliance.
Hob surfaces • Soak stains under a hot soapy cloth,
rinse and dry thoroughly.
• Hard water spots can be removed with
household white vinegar.
• Non-abrasive hob surface cleaners.
Regular use of a polish designed for
use with hobs will reduce fingerprints
and other marks.
• Never use harsh/abrasive cleaning
agents as they will damage the finish.
• Chlorine or chlorine compounds
in some cleaners are corrosive to
hob surface and may damage the
appearance of your hob. Check the
label on the cleaner before using.
Electrodes • Toothbrush. • A dirty or wet electrode will prevent
the burner lighting efficiently. Ensure
the appliance has been disconnected
from the electrical supply before
cleaning or drying.
Cleaning the Gas Hob
Maintenance Period Description
Daily • Clean gas hob as per the instructions.
Monthly • Remove all burner parts, and clean using a non-abrasive detergent. Rinse
in cold water, dry thoroughly, and replace.
• Clean the ignitor and probe carefully, using a toothbrush.
Every year • Contact your local authorized gas Service Agent to perform a thorough
check on all gas components on the gas hob.
Steam Cleaners must not be used to clean this product.
Cleaning and Maintenance
To avoid shock hazard, always disconnect the hob from the electrical supply.
LGHOBX12_IB_120601_Annie(Check).indd 9 12年6月1日 下午5:14

10
Burner parts Replacing the burner parts
The surface of the burner cover will gradually lose its gloss finish with time. This is quite normal and will not
effect the efficiency of the hob.
Replacing the Burners
Check that:
• The ignitor is always clean to ensure trouble-free sparking.
• The FSD probe is always clean to ensure correct operation of the safety valves.
Hob Controls
If you have problems with the hob controls (gas taps), call your Authorised Service Centre.
These parts are not user serviceable.
Burner Parts and Pan Supports
You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean spills regularly
before they become burnt on. Do not wash these parts in a dishwasher.
After cleaning, check that the burner rings and burner caps are dry before replacing correctly.
It is very important to check that the burner rings and burner caps have been correctly positioned.
Failure to do so can cause serious problems.
To avoid damage to the ignition circuit NEVER light the hob when the burners are not in place.
• Both the ignitor and probe must be very carefully cleaned using a toothbrush.
• When replacing the burner parts, ensure you do not damage the ignitor or temperature probes.
* All images are for indication only; please refer to your individual unit for actual item.
LGHOBX12_IB_120601_Annie(Check).indd 10 12年6月1日 下午5:14