LyxPro Boom Arm Stand User manual

BOOM ARM STAND
User Guide
Thank you for purchasing the LyxPro Boom Arm Stand. This User Guide is intended to provide you with guidelines to
ensure that operation of this product is safe and does not pose risk to the user. Any use that does not conform to the
guidelines described in this User Guide may void the limited warranty.
Please read all directions before using the product and retain this guide for reference. This product is intended for
household use only.
This product is covered by a limited one-year warranty. Coverage is subject to limits and exclusions. See warranty for
details.
Box contents
Boom arm stand
Clamp support base
Desk attachment
Velcro tags
User guide
™
Parts
1. Desk attachment
2. Desk clamp
3. Arm
4. Velcro tags
5. Microphone attachment
6. Mic attachment screw
7. Arm tightening screw
8. Adjustment spring
9. 5/8" screw adapter
5
6
7
2
3
4
8
9
1

Mounting via desk attachment
1. Choose a location to place the boom stand. Test the position of the stand before deciding, as you will be
permanently drilling holes into the desk.
2. Mark the location where you will be positioning the desk attachment, checking that it meets the
recommended distance .
3. Fasten the clamp to the desk by turning the handle until it is tight against the underside of the table.
Check that the clamp sits ush on both the top and bottom surfaces of the table.
4. Check that the clamp is securely mounted by attempting to pull it o of the surface. If the clamp comes
o easily, try reattaching it more tightly and test it again.
5. Insert the arm into the hole at the top of the clamp.
Care and maintenance
3. Pre-drill 3 holes into the marked area.
4. Screw the desk attachment into the desk.
6. Insert the arm into the top of the desk attachment. Twist the knob until tight and secure.
The boom stand is now installed and the microphone can be attached.
Mounting via desk clamp
1. Unscrew the clamp until the opening is large enough to t over the edge of the desk or table.
2. Push the clamp onto the table as far as it will go. This will make the attachment more secure.
Adjusting the tightening spring of the boom stand
1. Remove the spring by pulling it upwards and out of the screw
2. Unscrew the pin on the side of the arm.
3. Reinsert the pin into the desired hole
4. Screw the pin into place until tight and secure.
• Periodically wipe away dust with a soft dry cloth.
• Store in a safe place where the parts will not become lost or damaged.

www.lyxpro.com
Distributed by
C&A Marketing, Inc.
114 Tived Line East
Edison, NJ 08837
[email protected]
MADE IN CHINA
LyxPro is a trademark of C&A IP
Holdings, LLC
©2017 All Rights Reserved
Specications:
construction: aluminum
size of boom 42.5" (21" vertically and 21.5" horizontally)
max desk thickness for clamp 2.5"
max microphone weight 4 lbs
weight 2.25 lbs
Customer Service:
[e-mail]
866-849-3049
LyxPro is a trademark of C&A IP Holdings, LLC. Registered in the United States.