M.F. Blouin FFFP01568 User manual

M.F. BLOUIN
Merchandising Solution 710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • [email protected] Page-1
2-Sided Black Floor Poster Stand
ASSEMBLY INSTRUCTIONS Product No. FFFP01568
Parts & Hardware
Prior to assembly, please be sure all of the parts and hardware are present.
If you are missing any hardware, please call immediately.
(2) Black Legs
(2) Hex Bolts
(2) Threaded Rods
(4) Lock Knobs
Hex Wrench
Black Base
Black Spacer Panel
Acrylic Sign Holder

M.F. BLOUIN
Merchandising Solution 710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • [email protected] Page-2
2-Sided Black Floor Poster Stand
ASSEMBLY INSTRUCTIONS Product No. FFFP01568
Step 1:
Attach the black legs to base unit using the supplied
hex bolts & hex wrench - Position each leg keeping
keeping the top slots aligned. Hold each leg in place
while tightening the bolt(s) with the hex wrench.
DO NOT Twist the legs to tighten! Twisting the legs to
tighten may scratch the surface of the base unit.
* Be sure to keep the legs aligned so the slots are
running in the same direction to accept the sign holder
& spacer panel.
Tighten legs keeping
slots aligned

M.F. BLOUIN
Merchandising Solution 710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • [email protected] Page-3
2-Sided Black Floor Poster Stand
ASSEMBLY INSTRUCTIONS Product No. FFFP01568
Step 2:
After removing the poster holder &
spacer panel from its packaging, peel
off the protective film and insert the
spacer panel between the two sides
of the sign holder keeping the curved
corners to the bottom and roughly
aligning the holes.
* This is a convenient time to insert
your poster(s) and is recommended
but not necessary.
Step 3:
Insert the assembled poster holder
& spacer panel into the top slot of
the legs roughly aligning the holes.
Step 4:
Insert the threaded rods through holes
and tighten the lock knobs on each side
of the rods.
The display is now assembled!
Clean unit with acrylic cleaner (or mild detergent & water) and soft cloth only. DO NOT USE ALCOHOL!
For a small container of NOVUS Acrylic Cleaner call today!