M&M Monkey Jump MM00125 User manual

MM00125
HOW TO INFLATE INNER TUBE
1. Locate the valve extender. Unscrew and
remove the black cap on the end.
2. Next, take your inner tube and locate the
valve stem. Unscrew and remove the black
cap on the end.
3. Connect and thread the valve extender
onto the inner tube valve stem.
4. Aach your air chuck to the opposite end
of the valve stem extender. The use of a
needle valve tool is recommended.
5. Now that everything is connected, inate
the inner tube unl full. When inated,
the tube should measure approximately
20” high and ve feet wide. Standard inner
tube inaon to~6 psi (40kpa).
6. Once the tube is lled the valve stem
extender can be removed and the
black cap can be threaded back onto the
valve stem.
7. Slide the tube down over the top of the
Monkey Jump pole assembly. Make sure
the valve on the inner tube is facing down
toward the ground.
Valve Extender
Deated Inner Tube
Inated Inner Tube

M&M Sales Enterprises, Inc.
Dubuque, IA 52002 | 877-242-0154
www.mandmsalesinc.com
WHAT TO DO IF INNER TUBE IS LEAKING AIR
• If the Monkey Jump inner tube is losing air slow, check to ensure the needle
valve inside the valve stem is properly ghtened.
• Replacement Monkey Jump inner tubes are available. Please contact M&M
Sales Enterprises, Inc. at [phone] or visit www.mandmsales.com for
more informaon.
HOW TO MAINTAIN INNER TUBE
• For the best bounce, please make sure the inner tube is always full. It
will require adding addional air from me to me. Please be aware, the
lifespan of the inner tube will be determined by several factor. Direct
sunlight, over inaon of the tube, sharp objects and other misuses will
increase the chances of a blown inner tube.
• Before each use, the inner tube should be visually inspected for proper
inaon and any signs of visible damage that might cause it to pop during
use. Avoid using any objects that might cause damage to the inner tube
during play.