MEEPO V5 User manual

MANUAL
@MEEPOBOARD | WWW.MEEPOBOARD.COM MEEPO V5/MINI5

COMMUTE IN STYLE

READ THE MANUAL CAREFULLY
BEFORE YOU RIDE
Don't Panic when losing connection for a few seconds. In some
areas, due to radio interference, your board may get discon-
nected from your remote.
YOUR BOARD MAY LOSE CONNECTIONS
Be careful with the EXPERT and PRO Models, your board will
accelerate faster than usual. Crashes in these conditions may
cause serious injury, even for an experienced rider.
KNOW YOUR LIMITS
Be aware of complex road conditions, and always skate cau-
tiously when going in the presence of vehicles.
CARE FOR TRAFFIC
Safety first! Additional safety gear, like gloves, pads, and long
sleeves, is also highly recommended.
ALWAYS WEAR HELMET
Before you start riding on the street, please be aware of the
local laws that govern the use of your board on public roads,
bike paths, sidewalks, or other places that you may skate in.
KNOW YOUR LOCAL RESTRICTIONS

1
MEEPO V5 2
MEEPO MINI5
Front Truck
Front Wheels
Power Button
Charging Port
Deck
ESC and Battery Case
Hub Motors
Bushings
Front Truck
Front Wheels
Power Button
Charging Port
Deck
ESC and Battery Case
Hub Motors
Bushings
handle
761mm
968mm
282mm
282mm

3
M5 Remote
+
Pairing the Remote and Board
1. Turn on Meepo board, then long press the switch for 7 seconds.
2. Press the power button on the remote for 3 seconds to turn it on.
3. Press the power and function-button on the remote at the same
time.
After pairing, double press
to change 'forward' and 'backward'
Function 2.
Hold the throttle down and stay at
the brake position, press ‘‘function’
button to change brake mode.
Function 3.
Before pairing, press and hold
'power' and 'function' button at the
same time to change the speed units
between 'kph' and 'mph' .
Function 1.
Single press to change speed mode
from'LO' to 'MI', 'HI', and 'PRO'.
Brake
Acceleration
Power Button
Speed Mode
Skateboard
Battery Remaining
Remote Control
Battery Remaining
Lanyard
Type-c
Charging Port
5V/ 1A
Function Button
Connected
(Flashing green light）
Disconnected (Green light)
Backward Mode (Flashing red light）
100% 75% 50% 25%
PRO HI MI LO
(When the remote’s power on)
Flashing red light (Under 15%)
4
Power On/Off the Remote
5
Power On/Off the Board
Press the power-button
for 2 seconds
Press the power button once
or push-start the board.
2S
2S

Operating the Board with the Remote
2S
2S
• Make sure the old remote is turned off, if you have one.
• Hold the power button on the board for 7 seconds.
• Press the “power” and “function” buttons on the remote at the
same time.
• The connection light on the remote will flash green light.
• When the power button blinks rapidly and the remote displays all
the specs, the board and remote have been paired.
• After 10 minutes of standby, the ESC will automatically turn off, and then the
remote control will shut off 10 seconds later.
• But when the board and the remote control are not connected, the remote
control will shut off after 10 seconds of standby.
6
Check the Remote-Board Pairing*
* Your board and remote have already been paired in the factory. You need to
do the following procedure when pairing a new remote to a board.
• Turn on the board by pressing the power button on the board once.
• Turn on the remote by long pressing the “power” button on the
remote.
++
+
Forward
Brake
Skateboard
Battery Remaining
100% 75% 50% 25%
(When the remote’s power on)
The remote is equipped with
battery indicator lights below
the power button.
When your remote’s power on,
the remote lights will indicate
the power level.
7
Operating the Board with the Remote 8

10
Change Ride Mode
The board is set in beginner mode by default. Before switching modes, make
sure you have mastered the beginner mode.
LO: Limited acceleration, top speed of 11km/h (7mph).
MI: Moderate acceleration, top speed of 25km/h (15.5mph).
HI: High acceleration, top speed of 45km/h (28mph).
PRO: Max acceleration, top speed of 45km/h (28mph).
It usually takes the remote several hours to get fully charged. If the board and
remote are charged at the same time, the remote will be charged first.
CYCLE THROUGH SPEED /BRAKE MODES:
While holding the throttle down press the
function-button to change brake modes.
Press the function-button once to change
speed modes.
9
Riding Basics
R
L
Regular Goofy
Your Meepo board has a lot of power. Follow these tips to ensure a safe
riding experience:
ARE YOU A “REGULAR” OR “GOOFY” FOOTED RIDER?
Typically, if you kick a ball with your right foot, you are a regular footed
rider. However, this is not always the case! Try both stances to see what
feels best. If you don’ t know which to choose, one advantage of riding
goofy footed is that you have a better view of the traffic.
L
R
STANCE
• Move the throttle wheel in small increments.
• Keep a wide stance on the board.
• Keep a low center of gravity.
• Lean forward when accelerating.
• Lean backward when braking.

11
Charge the Remote
12
Charge the Board
Warning: Never leave your board
unattended while charging.
Charging Port
Charging Port
The remote takes several hours to
charge. If the board and remote are
charged at the same time, the remote
should finish charging before the board.
13
Get Ready to Ride
• Always wear a helmet.
• Find a flat, paved area with no obstacles for your first ride.
• Read and understand the entire manual.
• For more details, check out our website: www.meepoboard.com.
• Other protective equipment is highly recommended.
Downhill
Grates/Drains
Poor Visibility
Uphill
Tracks
Obstacles
Water
Larger Rocks
Night Time
Gravel
Cracks
Traffic
AVOID THESE OBJECTS AS THEY CAN MAKE YOU LOSE
CONTROL OR CRASH:

• To insert a new battery pack, align the grooves on both ends of the
connector (board & battery pack).
• Insert, connect, and adjust the two ends of the connector together.
Make sure to tighten the connector to make a good seal.
• Ensure the connector lays flat within the accessory wire and the groove
of the board.
• Replace and tighten the bolts with the hex wrench, and put the grip tape
back on.
14
Replace the Battery Pack
15
More Information Online
This manual is a quick start guide intended for someone with little experience
in riding electric skateboards. If you want to learn more on how to start riding,
superior riding skills, and solutions for riding problems, please visit our website:
www.meepoboard.com or send us a mail to [email protected].
GETTING STARTED
• How to stand on the board
• How to turn
• How to find a good spot to practice
ADVANCED TECHNIQUES
• How to footbrake
• How to ride uphill and downhill safely
• What to look for when riding through traffic
MAINTENANCE
• Pre-ride inspection
• Routine maintenance

BATTERY SAFETY AND HANDLING INFORMATION
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to instructions.
Failure to follow these safety instructions could result in fire,
electric shock, or other injury or damage to the Meepo
skateboard and Meepo remote or other property.
WARNING!
Whenever riding a electric skateboard, make safety your top priority.
Loss of control, collisions, and falls may cause serious injury to you.
Please ride responsibly and respect those around you. How you ride will
determine how people view this new mode of transportation.
Do not attempt to disassemble the product without
consulting Meepo. Should your unit need service, contact our
Customer Service by sending an email to [email protected].
If this equipment does radiate harmful interference to radio or television
reception, fix the problem by trying one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a different circuit from
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Prolonged exposure to sunlight may discolor or weaken the plastic cases, as
they are not UV Rated.
WARNING: AVOID WATER!
WARNING: PINCH POINTS
WARNING: RISK OF ELECTRIC SHOCK!
WARNING:
WARNING:
Always wear a helmet when riding. Never ride in the rain, or on wet,
slippery or uneven surfaces with steep hills, traffic, cracks, train tracks,
gravel, rocks or any obstacles that could cause a loss of traction. Avoid
night riding in areas with poor visibility or narrow spaces.
WARNING:
Riding in wet conditions or through puddles can
damage the board’s electronics and cause the board
to lose power or stop suddenly. Damage to the board
due to water exposure is not covered under the
warranty.
Keep fingers, hair, and clothing away from motors,
wheels, and all moving parts.
Do not open or tamper the case or battery with
cleaning products, this will void the board’s warranty.
This equipment has been tested and complies with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and
radiates radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
CAUTION
CAUTION
IMPORTANT SAFETY AND HANDLING INFORMATION

Changes or modifications to the skateboard unapproved by Meepo may void
the user’s warranty.
This product is intended to be equipped only with Meepo board batteries.
Do not drop or throw the battery.
Keep the battery away from kids.
Never expose this product or the battery to any liquids.
Never throw the battery into a fire, it could cause the battery to explode.
Never bring the connector terminals in contact with another metal object, it
will short-circuit the battery. Short-circuit could cause personal injury, fires or
damage to the battery.
Your device contains an internal rechargeable lithium-ion battery which may
present a risk of fire or chemical burn if mistreated. Do not charge or use the
unit in a car or places where the temperature surpasses 40°C.
Unplug the charger and disconnect it from the skateboard when not in use.
The charger supplied with the electric skateboard
should be regularly examined for damage to the
cord, plug, enclosure, and other parts. In the event
of such damage, the skateboard must not be
charged until the charger has been repaired or
replaced.
Unplug the charger and disconnect it from the skateboard when not in
use.
CAUTION
Power cord is used as a disconnection device. To fully de-energize
equipment for service, disconnect the charger power cord.
WARNING
BATTERY CHARGING INFORMATION
The charger is designed for indoor use only. Do not expose the charger to
liquid, moisture or extreme humidity. Do not charge Meepo skateboard or
Meepo remote outdoors or in the rain.
Stop charging the skateboard and/or remote if charging isn’ t completed
within the specified time.
Stop charging the skateboard and/or remote if the batteries become abnor-
mally hot, show signs of odor, discoloration, deformation, or if abnormal
conditions are detected during use, charging, or storage.
Do not charge the skateboard and/or remote if the battery enclosure
becomes cracked, swollen, or shows any other signs of damage. Discontinue
use immediately and promptly dispose of unit.
Your device should not be placed in municipal waste. Please check
local regulations for proper disposal of electronic products.
If this unit shows any type of damage, such as bulging, swelling, or malforma-
tion, discontinue use and immediately contact Customer Service by sending
a mail to [email protected].
Dispose of used batteries in accordance with the prevailing community regu-
lations that apply to the disposal of batteries.
Never dispose of used batteries with other ordinary solid wastes.
Batteries contain toxic substances.
PRODUCT AND BATTERY DISPOSAL INFORMATION:

MEEPO ELECTRIC
SKATEBOARD COMPANY
Online Store Customer Service
Room 2015, Trend Centre, 29-31 Cheung Lee Street, Chai Wan, Hong Kong
This board is covered by a 360 day manufacturer’ s warranty that covers
defects in workmanship and material. This does not cover damage caused by
abuse, misuse, negligence, accidents, or riding in water.
If the product has a manufacturing defect within 360 days of ship date,
contact [email protected]
Each board was tested for at least 20 miles before shipping it out. So it is
normal to spot some dirt or dust on the board, and certain mileage on the
remote.
Please keep your shipping box. The warranty does not include damage from
return shipping with lack of package material.
For any concerns regarding your board, please contact Meepo’ s customer
service by going to www.meepoboard.com or by emailing info@meepo-
board.com.
WARRANTY AND MAINTENANCE
LIMITED WARRANTY
Store your board in a dry area. If you are not going to ride your board for a
long time, fully charge your board at least once a month to unrecoverable
prevent irreversible battery damage.
MAINTENANCE FOR BOARD WHEN NOT BEING USED
FOR ALL RETURN AND WARRANTY SHIPPING:
If you accidentally ride in the rain or on wet surfaces, wipe off all the water on
the surface of your board, especially the charging port. Do not charge your
board until it is completely dry. Then, run the motors so that the wheels are
spinning for 10 minutes in order to dry the inside of the motors and avoid rust.
MAINTENANCE AFTER WET SURFACES
Company address
Online Store
www.meepoboard.com
Customer Service Email Address
[email protected]