MET MET1339 User manual

PLEASE READ BEFORE OPERATING THIS EQUIPMENT
INSTRUCTION MANUAL
2.1 BLUETOOTH SPEAKER SYSTEM
MODEL NO. MET1339
MET

2
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc) batteries.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Important Safety Instructions
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
Do not install near any heat sources such as
radiators, heat registers, stoves,or other apparatus
(including amplifiers) that produce heat.
Do not defeat the safely purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other, A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
Only use attachments/accessories specified by the
manufacturer.
Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus, When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury form tip-over.
Unplug this apparatus during lightning storms or
when unused for long periods of time.
Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord
or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.

LOCATION OF CONTROLS
3
VOLUME
TREBLE BASS
POWER SOURCE
AUX INPUT SPEAKER
OUTPUT
DC 6V
R
R
L
L
Pairing
Indicator
Treble Up/Down
Power ON/OFF Pair Bluetooth
Press to begin pairing.
Source
Press to switch between
Bluetooth and Line In modes.
Volume Up/Down
Bass Up/Down
RCA Audio Input
Stereo Speaker
Outputs
DC Jack
DC 6V

POWER SOURCE
4
Plug the included AC/DC Switching adapter (Input:100-240V~ 50/60Hz)
into the POWER JACK on the dock and an AC power outlet to power the dock.
AUX INPUT SPEAKER
OUTPUT
DC JACK
R
R
L
L
Bluetooth Wireless Audio
Pairing to a Device & Playing Audio
After initial pairing, the unit will stay paired unless unpaired manually by
the user or erased due to a reset of the device. If your device should become
1. Power ON the unit and press the Source button to switch to Bluetooth wireless mode.
2. Press the Pair button to begin pairing. The pairing indicator will begin
When pairing, remain within 3 feet of the unit.
3. Using the controls on your Bluetooth device, search for and select SHTIB1060-BT in
your Bluetooth settings to pair. If your device requests a password, enter the
default password 0 0 0 0 .
for instructions on pairing and connecting Bluetooth devices.
4. When successfully paired, the pairing indicator will turn solid blue.
Use the controls on the connected device to select and play audio.
Power
Audio Source & Speaker Connections
1. Using a 3.5mm to RCA cable (included), connect the RCA audio inputs to the audio output
of an external audio source or system.
2. Connect the left and right speaker cables to the left and right speaker outputs on the subwoofer.
3. To play audio from the connected external source, press the Source button to switch to Line In mode.
Audio from the connected source will now be heard through the speakers.
AUX INPUT SPEAKER
OUTPUT
DC JACK
R
R
L
L