MicroConnect MC-USB3.0-F2B2-V2 User manual

1
PCIe USB3.0 3+1 Ports Expansion Card VL805
P/N: MC-USB3.0-F2B2-V2

2
Introduction
This production is a single chip USB 3.0 Host controller which enables a PCI Express equipped platform to
interface with USB Super-Speed(5Gbps),High-Speed(480Mbps),Full-Speed(12Mbps), and Low-Speed
(1.5Mbps) devices, Users can easy to connect your Mass Storage, Printer, Scanner , Hub, Camera and any
other USB Devices to used.
Features and Benefits
Compliant to Universal Serial Bus 3.0 Specification Revision 1.0
Compliant to Universal Serial Bus 2.0 Specifications
Compliant to eXtensible Host Controller Interface Specification Revision 1.0
Compliant with PCI Express base specification 2.0
Support Legacy USB Function, Four Down-stream ports Support Super-Speed(SS)
High-Speed(HS),Full-Speed(FS) and Low-Speed(LS)
Max. 5V/900mA power output to each USB 3.0 Port
4-pin power connector for extra power
Fully plug ,play and hot plug compatible
Interface
PCI-Express X1
Connectors:
4 x USB3.0 Connectors
System Requirements
* Windows®XP/Vista/7 /8(32/64 bit)

3
* Available PCI-Express X1 slot
Package Contents
1x PCI-Express USB3.0 4PORTS
1x Manual
1x Driver CD
Hardware Installation
Step 1: Turn off your PC, unplug the power Card and open the case of PC.
Step 2: Remove the mini PCIe Slot cover as below.
Step 3: Plug USB3.0 PCIe card in mini PCIe Slot and install the bracket screw that secures the
card to the computer chassis.
Step4: Replace the computer chassis cover, reconnect the Computer Power Card and turn on
your PC.
Driver Installation
1. For Windows®XP/Vista/Win7 (32/64 bit)
2. 1. Please insert the CD driver bound with USB 3.0 4-Port PCI Express Card into your
CD-ROM Drive.
3. 2. At the Windows desktop, click Start, Run.
4. 3. Type“USB3.0 VL805-806\V3.10C_WHQL \Setup.exe”, click OK.
5. 4. Follow the on-screen instructions to complete the installation.

4
To Verify Driver Installation
Click on the “Device Manager”tab in System Properties, which you access from the
Windows Control Panel. You should see a “VIA USB 3.0 Root Hub”and a “VIA USB eXtensible
Host Controller”under the “Universal Serial Bus controllers”item.