MicroNet C5234 User manual

Communicate via
Quick Installation Guide
Model No.: C5234
V1.0
www.micronet.com.tw
6
5
7
In-Ceiling (T-Bar) Mount Kit
P/N 2300-0716
NOTE: Please make sure
the Wings of the T-Bar
Bracket are completely flush
with the ceiling board.
STEP 12
Tighten the screws to fix T-Bar Bottom Mount on the T-Bar Bracket.
STEP 13
Fix the Trim Ring to the T-Bar Bracket.
STEP10
Put the Power Cable and Ethernet Cable down through the
center hole of the T-bar and connect it to the Camera.
STEP 11
Put up the installed T-Bar Bottom Mount with Camera into the
ceiling opening.

STEP 8
Put up the T-Bar Bracket into the
ceiling opening and fix the In-
Ceiling (T-Bar) Mount on the
ceiling by tightening three screws
clockwise.
STEP 9
When screwing, the Wings will
get approached to the ceiling
board until it is completely flush
with the board.
4
3
1 2
STEP 1
Remove the outdoor sunshield
by removing the screws on the
top.
STEP 2
Follow by removing the outdoor
base by removing the screws on
the top
STEP 3
After the outdoor base is
removed carefully replace it with
the indoor base
And then tighten the screws on
the top
Here lists the items and tools needed to mount the Speed Dome
Camera into the ceilings.
Package Contents
Lock Bar x1
M3x6 Screw x2
Ceiling Sticker x1
Trim Ring x1
Indoor base x1
Items Needed
Speed Dome Camera
Power Cable
Ethernet Cable
T-Bar
Ceiling Sticker (equipped with T-Bar )
Tools Needed
Tool for cutting a circle on the ceiling
(+,-) Screw Driver
Follow the steps to install the Dome Camera with T-Bar
Ceiling mount accessory for in-ceiling mounting.
STEP 4
Install the Camera on the fixed
Hard Ceiling Mount by turning the
Camera clockwise. Then tighten
the screw at the side of the Fixing
Plate.
STEP 5
Tighten the screw at the side of
the Fixing Plate. Finishes install
Camera on T-Bar Bottom Mount.
STEP 6
Place the Ceiling Sticker on the
ceiling plate, and cut the circle
part out of the ceiling.
STEP 7
Disassemble the wings from the In-Ceiling (T-Bar) Mount by
loosening three screws counterclockwise (indicated in the diagram).
Loosen the screws till the wings are loosed enough and turn out
from the ring. (as shown in the second diagram)