Mounting Dream Anti-tip Strap User manual

Please read this instruction carefully before installation.
Anti-tip Strap INSTALLATION INSTRUCTION
(A0)
If you have any questions, please feel free to contact us:
USA E-mail: [e-mail]
Phone call: [phone] (USA) Mon - Fri 10am - 6pm (Pacific Time)
EU E-mail: [e-mail]

WARNING:This product contains small items that could be a choking hazard if swallowed. Before
starting assembly, verify all parts are included and undamaged. For parts shortage or damage, please contact
us via [e-mail] (USA) or [e-mail] (EU).
NOTE: Not all hardware included will be used.
Installation Tools:
2M2M
Bubble Level Band Tape Screwdriver
Part List:
Anti-tip Strap 1pc
Installation Hardware:
- Lag Bolt 1pc
For concrete installations ONLY
CAUTION:Do not use in drywall or wood
stud.
- Concrete Anchor 1pc
- M4X20 Bolt 2pcs
1

2
Figure 1
Attach one end of the anti-tip strap to table top TV stand by using
bolt with Allen key (Bolt and Allen key are both included in the hardware
package of MD5109). (Figure 1)

Figure 2
3
Step 2A Strap attaches to the table See Page 3
Step 2B Strap attaches to the wall See Page 5
Attach the other end of strap to the wooden table by using bolts
with screwdriver. (Figure 2)

Adjust the length of strap,make sure it is tightened firmly and safe
enough. (Figure 3)
Figure 3
4

Use a stud finder to make marks at the edges of one stud, and mark
centerline of stud. Then place iron plate along the centerline and use
pencil to mark center hole location on the wall.
Use 1/16" diameter drill bit to drill a hole at marked position to a depth
of 1.4".
Put lag bolt into the drilled hole, and tighten the bolt by using a
screwdriver to mount the plate securely. (Figure 4)
5
drywall with
wood stud
Figure 4
Option 1：Wood Stud Installation

Figure 5
Concrete
wall
6
Use 1/4"(6.4mm) diameter drill bit to drill a hole at marked position to a
depth of 1.4".
Put anchor into drilled hole, and tap the anchor flush with the wall
by using a hammer. Then put lag bolt into the anchor, and tighten
bolt by using a screwdriver to mount the wall plate securely. (Figure 5)
Option 2：Solid Conrete Wall Installation

Figure 6
7
Adjust the length of strap,make sure it tight and safe. (Figure 6)