MRdirect 766 User manual

Installation Guide 1
Model 766
Spring-Spout Kitchen Faucet
Tools
Certifications & Information
Configuration
Installation Guide
Gather the necessary tools as shown to complete the installation of this faucet.
Connect to water supply lines with TWO
3/8" Compression Faucet Connectors
The following tools are optional:
FlashlightSafety Glasses
One-Hole Installation
Three-Hole Installation with Base Plate
Channel Lock
Adjustable Wrench
Pliers
Faucet
Sir
Water supply
Connector
• NSF Certified
• UPC & cUPC Certified
• Lead-Free Construction
• ADA Approved
• Limited Lifetime Warranty
Phillips Screwdriver
1 3/8"
* This measurement is only suggestive and may vary
according to the sink model.
Aerator Flow Rate
2.08gpm at 60PSI
Spray Flow Rate
2.05gpm at 60PSI

2
Installation Guide
Faucet Installation
A.
C.
E.
B.
D.
F.
Turn o the water supply. Remove the faucet
with the mounting hardware attached from
the package.
Insert the shank of the faucet body into the
hole of the sink deck. If installing a base plate,
insert the faucet shank through the base plate
rst, and then into the holes of the sink deck.
Hand-tighten the lock nut until secure.
Then, use a screwdriver to tighten each
screw slightly until all are secure.
Remove all mounting hardware from the shank.
From the underside of the sink or mounting
surface, attach the washer, followed by the
lock nut, and screws onto the shank.
Connect 3/8" compression ttings to each
hose, and then to each corresponding water
supply line. Secure each tting with a 1/4
turn of a wrench.
A
C
E
D
F
B
shank
1
2
Water supply
Connector
sink deck

3
Installation Guide
Important
To prevent damage to the tube body, tighten the connections by carefully using
two wrenches as shown. Use caution to not bend the stem.
Check for leaks.
Turn on the water supply SLOWLY, to test for leaks
before completely opening the water lines.
Maintenance & Cleaning
The faucet can be cleaned by rinsing with clear water or washing with mild detergents. Dry the faucet with a clean, soft cotton cloth.
CAUTION: do not use any cleaning agents containing acids, abrasives, or other harsh chemicals.
Simply rinse and dry faucets with a soft towel every week to prevent
mineral deposits from forming. Clean spills and splatters as they
happen. Do not let soap, toothpaste or other contaminates dry on the
faucet, this can stain or pit the nish. Use a mild soap and soft sponge
Never use an abrasive cleaner or rough sponge to clean or dry your
faucet. Harsh cleaners could dull or scratch the nish. Use only a soft
disinfectant that does not contain bleach or chlorine and apply with a
Pull the spray head from the faucet body and disconnect it by unscrewing
it from the spray hose. Once the spray head is disconnected, remove the
aerator washer from the hose and direct the open end of the hose into the
sink. Operate the faucet handle in the hot and cold positions to ush each line
for at least one minute. When complete, place the washer back into the end
of the hose and reconnect the spray head. Place the spray head back into the
faucet body.

Installation Guide 4
Notes
www.mrdirectint.com
[email protected]
1-877-946-5725
Warranty Information
MR Direct warrants to the original consumer purchaser that our sinks and faucets will be free from defects in
material and workmanship under normal use for the lifetime of the product. MR Direct may elect to repair or
replace any defective MR Direct product covered by our warranty.
Our warranty does not cover defects caused by misuse, abuse, negligence, alterations, environmental
conditions, improper installation, storage and handling; nor any labor expenses.
From time to time we will change design specications and materials as conditions require and
improvements are developed. We have no obligation to incorporate such changes in products we previously
manufactured.
This warranty is in lieu of any and all other warranties, express or implied, including any warranties of
merchantability and of tness for a particular purpose; and excludes any incidental or consequential
damages. No representative has the authority to change or enlarge the above warranty.
This warranty is only valid in the United States of America. Some states do not allow limitations on how long
an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above
limitations or exclusion may not apply. This warranty gives you specic legal rights, and you may also have
other rights which vary from state to state.
One-Year Accessory Warranty
MR Direct warrants to the original purchaser that all of our accessories will be free from defects in material
and workmanship under normal use for one full year.
Our warranty does not cover defects caused by misuse, abuse, negligence, alterations, environmental
conditions, improper installation, storage and handling; nor any labor expenses. MR Direct may elect to
repair or replace any defective MR Direct accessory covered by our warranty.