nuskin ageLOC Boost User manual
™
USER’S MANUAL
32
CONTENTS
ageLOC Boost™Device
Quick Start Guide
Magnetic Charger
Protective Treatment Surface Cover
Treatment products designed for use with
ageLOC Boost are sold separately.
TABLE OF CONTENTS
CONTENTS
SAFETY INSTRUCTIONS,
WARNINGS, AND
PRECAUTIONS
BEFORE YOU BEGIN
CHARGING YOUR
AGELOC BOOST™ DEVICE
USAGE INSTRUCTIONS
CLEANING AND CARING
FOR YOUR AGELOC BOOST
DEVICE
TROUBLESHOOTING
DEVICE DISPOSAL
MAINTENANCE
REPLACEMENT AND
WARRANTY INFORMATION
PATENTS
DEFINITION OF SYMBOLS
™
USER’S MANUAL
™
USER’S MANUAL
PMS 319
PMS Color
PMS 184
PMS Color
PMS8401
PMS Color
PMS Color
PMS Color
FileName:
01 001931 94512316-1_ageLOCBoost QSG vrtcl inser t
Formula:
Formula
Dimensionsand Colors
0” width 0” depth 0” height
AGELOC BOOST™
QUICKSTART GUIDE
Fully charge ageLOC Boost before
using for the first time.
40 mL
℮
(1.35 FL. OZ.)
ACTIVATING
SERUM
™
Use with ageLOC Boost Activating
Serum after cleansing and toning.
USING AGELOC BOOST
Turn on device by swiping finger up
full length of touch surface.
Touch Surf ace
Touch Surf ace
Dispense three pumps of ageLOC
Boost Activating Serum onto the
device treatment surface. Spread over
one half of the face.
Massage excess Activating Serum into
skin, then follow with daily serum and
moisturizer. Device will automatically
turn o.)
Begin treatment by swiping finger
up full length of touch surface. Glide
treatment surface over face in an
upward/outward motion.
Repeat
STEPS 2
&
STEPS 3
on other
half of the face.
1 min
1 min
X
TO PAUSE:
Swipe down full length of
touch surface. To resume, swipe up full
length of touch surface.
TO STOP TRE ATMENT MA NUALLY:
Swipe down full length of touch
surface twice.
001931-94512316-1_ageLOC-Boost-QSG-vrtcl-insert.indd 1001931-94512316-1_ageLOC-Boost-QSG-vrtcl-insert.indd 1 5/1/20 12:25 PM5/1/20 12:25 PM
™
USER’S MANUAL
PMS 319
PMS Color
PMS 184
PMS Color
PMS8401
PMS Color
PMS Color
PMS Color
FileName: 01 001931 94512316-1_ageLOCBoost QSG vrtcl inser t
Formula: Formula
Dimensionsand Colors 0” width 0” depth 0” height
AGELOC BOOST™
QUICKSTART GUIDE
Fully charge ageLOC Boost before
using for the first time.
40 mL ℮ (1.35 FL. OZ.)
ACTIVATING
SERUM
™
Use with ageLOC Boost Activating
Serum after cleansing and toning.
USING AGELOC BOOST
Turn on device by swiping finger up
full length of touch surface.
Touch Surf ace
Touch Surf ace
Dispense three pumps of ageLOC
Boost Activating Serum onto the
device treatment surface. Spread over
one half of the face.
Massage excess Activating Serum into
skin, then follow with daily serum and
moisturizer. Device will automatically
turn o.)
Begin treatment by swiping finger
up full length of touch surface. Glide
treatment surface over face in an
upward/outward motion.
Repeat ST EPS 2 & STEPS 3 on other
half of the face.
1 min
1 min
X
TO PAUSE: Swipe down full length of
touch surface. To resume, swipe up full
length of touch surface.
TO STOP TRE ATMENT MA NUALLY:
Swipe down full length of touch
surface twice.
001931-94512316-1_ageLOC-Boost-QSG-vrtcl-insert.indd 1001931-94512316-1_ageLOC-Boost-QSG-vrtcl-insert.indd 1 5/1/20 12:25 PM5/1/20 12:25 PM
54
be pulled into a bathtub, shower, sink,
or toilet.
iPeriodically inspect for damage; never
operate the device if it has been damaged.
iageLOC Boost contains a lithium-
polymer battery. To prevent the
possibility of explosion, never expose
the device to heat. Do not store near a
heat source, such as a radiator, fire, or
heat vent. Do not leave in a hot vehicle.
Check with your carrier before shipping
or flying with this device.
iRechargeable batteries, like those of
ageLOC Boost, need to carry a minimal
charge in order to function properly.
We recommend charging your device
whenever low battery is indicated.
iNote, ageLOC Boost is charged using
inductive charging. Always use the
provided charger when charging. Do
not attempt to charge using any other
inductive charger. If damaged, contact
Nu Skin Support Services.
iDo not charge this device in the bathroom
or near water.
iDo not use harsh chemicals or abrasives
on your ageLOC Boost device.
iDo not leave ageLOC Boost in a cold
environment for prolonged periods of
time.
iAlways place your device on a heat-
resistant, stable, flat surface, especially
when charging.
iUse ageLOC Boost only as directed.
SAFETY INSTRUCTIONS,
WARNINGS, AND
PRECAUTIONS
ageLOC Boost™and Magnetic Charger
are tested at pressures matching 4000 m
in altitude.
This appliance contains batteries that are
non-replaceable.
WARNING: For the purposes of
recharging the battery, only use the Magnetic
Charger provided with this appliance.
iThe ageLOC Boost™device is only for
use on healthy skin. Do not use if you
have open sores or wounds, are prone
to rosacea, have allergies to metal, or if
you have problematic or overly sensi-
tive skin. Check with your physician
before using if you are pregnant, have
a pacemaker or similar device, are epi-
leptic, wear metal braces on your teeth,
have a metal implant, or are ill.
iageLOC Boost is not intended for use
by persons (including children) with
reduced physical, sensory, or mental
capabilities or who lack experience
and knowledge. Keep out of reach
of children.
iDo not apply directly to lips, eyes, or
eyelids. The device and treatment
product are for external use only. If you
experience any prolonged redness or
abnormal irritation, discontinue use
immediately and seek medical advice
if necessary.
iTo reduce the risk of shock, burn, fire,
or injury, do not fully immerse your
ageLOC Boost device in water. Do
not place or store where it may fall or
76
When charging begins, ageLOC Boost will
vibrate once and the LED light bar will slowly
cycle up—this indicates the device is charging
and displays the current level of battery charge.
After two minutes, the light bars will glow on
and o to indicate the current battery level.
Once the device is fully charged, the lights
will stop glowing on and o and the LED
light bars will remain dimly lit.
ageLOC Boost™is charged using inductive
charging. Always use the provided charger
to charge the device. Do not attempt to
charge using any other inductive charger. If
damaged, contact Nu Skin Support Services.
BEFORE YOU BEGIN
Please read all safety and technical
information before operating ageLOC
Boost.
™
CHARGING YOUR
AGELOC BOOST™ DEVICE
Fully charge ageLOC Boost before using for
the first time.
Before charging, make sure both the device
and the magnetic charger are completely dry.
Place the device on the magnetic charger (in
the correct position, see diagram). Make sure
the magnets snap into position. Plug the USB
cable into a power source.
Charge ageLOC Boost completely. When
used as recommended, a fully charged
device will last approximately one month.
98
STEP 2 Dispense three pumps of ageLOC
Boost Activating Serum onto the device’s
treatment surface. Using the device, spread
Activating Serum evenly over one half
of your face.
STEP 3 Begin treatment by swiping your finger
up over the full length of the touch surface.
The device will gently vibrate indicating
treatment is in progress. Place treatment
surface on face and begin treating skin by
using slow movements in an upward and
outward motion for one minute.
USAGE INSTRUCTIONS
Use ageLOC Boost™as part of your morning
skin care routine, after cleansing and toning.
PLEASE NOTE: ageLOC Boost has been
specifically designed to be used with ageLOC
Boost Activating Serum. For your safety
and comfort, we do not recommend using
the device with any product other than
Activating Serum.
TREATMENT TIME
A treatment consists of two (2) one-minute,
half-face treatments. After one minute,
ageLOC Boost will pause briefly to allow
you to apply additional ageLOC Boost
Activating Serum to the treatment surface
before you begin treating the
second half of your face.
STEP 1 Turn on the device by swiping your
finger up over the full length of the touch
surface. Lights will turn on.
Touch Surface
Touch Surface
1 min
1110
TO PAUSE TREATMENT At any time, simply
swipe down over the full length of the touch
surface. Swipe back up full length of touch
surface to resume.
pause resu m e
TO STOP TREATMENT MANUALLY during a
treatment, you can stop the device at any time
by swiping down the full length of the touch
surface two times.
X
PLEASE NOTE: ageLOC Boost was designed
to slowly glide across the skin’s surface during
use and should not be held in one spot. If you
experience any prolonged redness or abnormal
irritation, discontinue use immediately and
seek medical advice if necessary.
STEP 4 After the first one-minute treatment
is complete, the device will pause
automatically. Dispense an additional three
pumps onto the treatment surface of the
device, and spread evenly over the other half
of the face. Swipe up the full length of the
touch surface. The device will resume gently
vibrating. Continue to treat the skin using
slow, upward and outward motions for the
remaining minute.
STEP 5 The device will automatically turn o
after completing a full treatment cycle. Once
treatment is complete, massage excess into
skin, then follow with your daily serum and
moisturizer.
Touch Surface
1 min
1312
CLEANING AND
CARING FOR YOUR
AGELOC BOOST™ DEVICE
ageLOC Boost should be cleaned according
to these instructions after each use to avoid
the accumulation of residue. After every
treatment, rinse ageLOC Boost treatment
surface under running water to ensure debris
and product is removed from crevices.
Thoroughly wipe the device dry with a soft
washcloth. Store in a dry place.
TROUBLESHOOTING
LOSS OF CONDUCTIVITY DURING
TRE ATMENT: If the microcurrent conductivity
is temporarily lost, the device’s LED light bar
will flash in continuous sets of five short flashes
coupled with five sharp vibrations. If this
happens, apply more ageLOC Boost
Activating Serum to the device’s treatment
surface. Swipe up along the touch surface to
resume treatment.
UNRESPONSIVE DEVICE: Swipe up slowly
from the bottom of the device along the full
length of the touch surface. If the device still
does not respond, charge it fully and try again.
If the device still fails to respond, contact
Nu Skin Support Services.
LOW BATTERY: The bottom light on the
device will turn amber. Charge the device.
EXTREME LOW BATTERY: The amber light at
the bottom of ageLOC Boost™will flash
repeatedly when the user attempts to start
a treatment. This indicates there is not enough
battery remaining to perform a treatment, and
the device will turn o. Charge the device.
DEVICE DISPOSAL
You must dispose of ageLOC Boost properly
according to local laws and regulations.
ageLOC Boost contains electronic
components and a lithium-polymer battery,
which requires disposal separate from
household waste. When ageLOC Boost
reaches its end of life, contact your local
waste management department to learn
about proper disposal and recycling options.
Dispose of Batteries Properly for Your Area
1514
MAINTENANCE
Do not attempt to repair the device yourself.
There are no user-serviceable parts.
Do not ship damaged devices by air.
ageLOC Boost™
Maximum Output:
V, µA, . Hz
IP
ageLOC Boost Magnetic Charger
Input: V mA
IP
In Canada, this device complies with
requirements of ICESGEN, ICES, and
ICES. This charger complies with the
requirements of ICESGEN, ICES, and
RSS.
FOR THE DEVICE: CAN ICESB/
NMBICESB
FOR THE CHARGER: CAN ICES
B/NMBICESB
REPLACEMENT AND
WARRANTY INFORMATION
LIMITED TWO-YEAR WARRANTY: Nu Skin
guarantees your device to be free from
defects in materials and workmanship for a
period of two years from the original date of
consumer purchase. This warranty does not
cover damage to the product as a result of
misuse or accident, including dropping the
device. If the product becomes defective
within the two-year warranty period, please
call your local Nu Skin Support Services.
PATENTS
Numerous U.S. and international patents
pending.
DEFINITION OF SYMBOLS
Symbol Definition
iWarning
Consult Owner’s Manual
Dispose of Batteries
Properly for Your Area
Two Levels of Shock
Protection
Charge only with specified
charger
Direct Current
SOLD EXCLUSIVELY BY NU SKIN ENTERPRISES AUTHORIZED
DISTRIBUTORS
MFD. IN CHINA EXCLUSIVELY FOR NSE PRODUCTS, INC.
© NSE PRODUCTS, INC., PROVO, UT NUSKIN.COM
