Oontz SUP Mount & Bracket User manual

for OontZ Bluetooth Speakers
Attaching the OontZ Speaker Bracket & Mount to the OontZ Angle 3 ULTRA SUP Special Edition Speaker.
Designed specially for the OontZ Angle 3 ULTRA SUP Special Edition Speaker.
User Guide

Assemble the OontZ SUP Mount and Base to your Paddleboard,
Surfboard or other smooth surface.
- Adheres best to smooth surfaces such as epoxy,
ABS and fiberglass.
- Rough surfaces or glass may not adhere firmly and cause the
mount with the speaker attached to fall off.
1) Peel off the yellow cover on one side of the 3M tape.
2) Press the side of the 3M tape with the yellow cover
removed to the bottom of the OontZ SUP Mount and Base.
3) Peel off the red cover from the 3M Tape.
4) Place the OontZ SUP Mount and Base on the dry, smooth
surface and press down to adhere the mount to the surface.
3M Tape
1
OontZ SUP
Mount and Base
Note: After placing the OontZ
SUP Mount on the surface, it
is recommnended to keep the
surface dry and let the 3M tape
adhere to the surface for a
minimum of 20 minutes
before use.

3
Loosen the adjustment
knob on the back of the
bracket until the bracket
is wide enough to fit on
the bottom of the
speaker.
Adjustment
Knob
2
OontZ Speaker Bracket
Attach the OontZ SUP Mount
to the OontZ Speaker Bracket.
1) Place the bottom of the
OontZ Speaker Bracket into
the slots of the OontZ SUP Mount.
2) Insert the Thumb Screw
into the OontZ SUP Mount.
3) Tighten the Thumb Screw
to secure the bracket to the
mount. When tightened the
speaker will stay in position. OontZ SUP
Mount
OontZ Speaker
Bracket
Thumb
Screw

5
Turn the adjustment knob
on the side of the bracket
until the bracket
firmly clamps
to the speaker.
Note: There will be a
small gap between the
bottom of the speaker
and the top flat surface
of the bracket.
While holding the assembled Oontz
Bracket and Mount, place the
the bottom of the speaker into the
bracket. The curved portion of the
bracket should fit to the curved
bottom of the speaker.
4
Note: Do not over tighten as it
may damage the bracket.

6
Note: If using in salt water environments, after
use rinse with fresh water, wipe off the water
and place in a dry place.
This will keep the speaker, bracket & mount
from rusting over time.
The assembled OontZ SUP
Bracket, Mount and Speaker
can be detached from the
OontZ SUP Mount Base on
your Paddleboard, Surfboard,
etc.
Firmly press together the clips
on the side of the OontZ SUP
Mount and slide the OontZ
SUP Mount out of the OontZ
SUP Mount Base.
OontZ SUP
Mount Base
OontZ SUP
Mount
Customer Support
If you have a question about your OontZ Speaker
Bracket or Clamp Mount, out Customer Serivce
Team wants to assist you.
Contact us at:
TheOontZ.com/support
and fill in our customer service form