Oypla Kids 4340 User manual

Wooden Sand Pit
User Manual
USER MANUAL Model No: 4340

Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
This product is not a toy, and is only to be used for its designated purpose.
Move to the final position before filling the planter.
Only use this product on stable, level and dry ground.
This is a garden planter, do not use as a wheelbarrow.
Do not discard any of the packaging until you have checked that you have all of the
parts and fittings required.
This product is intended for outdoor use only.
Leaving the product outside exposed to weather, especially direct sun and rain, will
speed the weathering process. This can be slowed by removing the product from
these conditions.
This product contains small parts that could be a choking hazard if swallowed. Keep
these items away from children.
Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be tightened
before use.
If the product is damaged or has any defects, please contact cs[email protected]
Care and Maintenance
Preserve the wood using timber treatment. Follow the directions on the can after
first checking that it is not harmful to plants.
USER MANUAL Model No: 4340

USER MANUAL Model No: 4340
Operating Instructions
If you are missing any of the below parts please contact [email protected]om
Please be aware that you will be referring to this parts list throughout the assembly process.
Parts List:

1. Slot two of the frame sections (A) together, with the grooves of the rear
section facing down and of the side section facing up.
2. Slot together the second side section.
3. Slot together the final section.
4. Line up the frame top (C) with the top of the frame, making sure that all
the screw holes correspond to the correct position on the frame.
5. Secure the frame top into place using five #4 screws.
6. Secure the remaining three frame tops, ensuring that the (C) tops are
placed at the side and the (B) tops and placed at the front and back.
7. Slide the roof supports (D) through the holes in the side frame tops and
secure using two #3 screws on each side.
8. Attach the frame top support pieces (I) to the front and back of the frame
using two #3 screws on each side.
USER MANUAL Model No: 4340

9. Check that the roof supports are correctly secured and are in a straight position.
10.Attach the roof frames (E) to the roof supports using a #1 screw on each side.
11.Attach a roof support bar (G) at the side of the roof frame using two #2 screws.
12.Once the first bar is secured, make sure that the roof frame is straight.
13.Attach the central roof support bar (F) in the centre of the roof frame using two
#2 screws.
14.Attach the remaining roof support bar.
15.Fit the canopy on top of the roof frame and insert the ground sheet into the
base before filling with sand.
USER MANUAL Model No: 4340

USER MANUAL Model No: 4185
USER MANUAL Model No: 4340