PARRY MWBT User manual

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 1 of 15
www.parry.co.uk
INSTRUCTIONS
MODEL: MWBT
SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
MAINTENANCE INSTRUCTIONS
WIRING DIAGRAM
EXPLODED VIEW / PARTS LIST
WARRANTY INFORMATION
DISPOSAL INFORMATION
Customer Information
MODEL NUMBER:
______________________
SERIAL NUMBER:
______________________
PURCHASE DATE:
______________________
DISTRIBUTOR:
______________________

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 2 of 15
www.parry.co.uk
SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ INSTRUCTIONS FULLY BEFORE USE
Please be aware that surfaces on this machine may get very hot during, and after
use.
ALL APPLIANCES OTHER THAN THOSE FITTED WITH A SEALED
MOULDED PLUG MUST BE FITTED BY A QUALIFIED ELECTRICIAN, IN
ACCORDANCE WITH CURRENT REGULATIONS.
The unit should be installed in compliance with the INSTALLATION
INSTRUCTIONS and the NATIONAL REGULATIONS in force at the time.
Particular attention should be paid to the Health and Safety at Work Act.
To prevent shocks, all appliances whether gas or electric, must be earthed.
To avoid scratching the highly polished exterior surface of this equipment whilst
in transit, the protective film on the exterior surfaces has NOT been removed.
It is IMPORTANT that this protective film is peeled off before the equipment is
used.
ENSURE THE APPLIANCE IS ISOLATED FROM THE POWER SUPPLY
BEFORE INSTALLING, CLEANING OR MAINTAINING THE APPLIANCE

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 3 of 15
www.parry.co.uk
INSTALLATION INSTRUCTIONS
This unit is supplied with a moulded plug
(Optional Extras)
A = Splash Back
B = Soap Dispenser Holder
C = Paper Towel Holder

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 4 of 15
www.parry.co.uk
Optional Extra Fitting Instructions
Remove screws from
handle (A).
Remove both screws
from each side (B).
Place the splashback
(C) on to unit and
replace screws from
(B)
Fitting Soap / Towel holders
Loosen screws (D) in
splashback.
Locate Soap holder /
Towel holder on to the
screws and tighten.
OPERATION INSTRUCTIONS
Position mobile wash basin in desired location.
Remove water tank cover by turning the knob to gain access to water tank. Fill
with water to maximum water level tab, as shown in image below

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 5 of 15
www.parry.co.uk
Ensure waste bucket is in position and the waste pipe is placed inside the
bucket.
Plug into suitable 13amp protected supply.
Ensure switch is in the on position and the red neon illuminated. (Shown in image
below)
Allow 20mins for the water to reach temperature before use.
To fill basin with water use the foot pump at the front of the machine.
Unit is protected from overheating by a control stat. If the tank has an insufficient
amount of water in it, a pressure switch will cut electricity supply to the element
preventing boiling dry, and damage to the element.

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 6 of 15
www.parry.co.uk
Before moving unit to new location make sure water tank is emptied by tap
located on the bottom of the tank as shown in the photo.
Do not attempt to move unit when full of water.
Please note that the waste bucket should be emptied regularly.
IMPORTANT NOTE
After service all water must be drain from the tank.
Disconnect form mains power supply.
Place the bucket below the drain tap. Turn tap and empty the tank.

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 7 of 15
www.parry.co.uk
MAINTENANCE INSTRUCTIONS
Servicing
This appliance should be routinely serviced to prolong its lifetime. Parry
recommends that the appliance is serviced every 12 months by a Parry
authorised engineer. Failure to service your product within the initial 12
month warranty period will cause the 24 month warranty to become void.
MAINTENANCE AND SERVICE MUST ONLY BE UNDERTAKEN BY A
QUALIFIED ELECTRICIAN.
Care and Cleaning
IMPORTANT NOTE
Turn off the mains switch before commencing any of the below.
Proprietary cleaners must be used with care –they are highly corrosive and may
cause damage to surfaces and components.
To clean unit wipe down with warm soapy water.
DO NOT USE SCOURING PADS.

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 8 of 15
www.parry.co.uk
WIRING DIAGRAM

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 9 of 15
www.parry.co.uk
EXPLODED VIEW
(MWBT SHOWN BELOW)
PARTS LIST
ID
DESCRIPTION
PART CODE
1
M16 Gland & Nut
GLAND0M16
LOCKNTM16
2
Plastic Bush
BUPL50006
3
*Gear Tray
*NO CODE
4
Terminal Block
TB3POLETB
5
Pressure Switch
10706/A
6
Thermostat
MWB44CSTAT
7
Barbed Tail
MWBBSPTAIL
8
Sealing Washer (x2)
MWBSEALWASH
9
Brass Lock Nut
MWBLOCKNUT

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 10 of 15
www.parry.co.uk
10
Switch
SWRE06165
11
Switch Cover
LE25COVER
12
Ball Valve
VALVEB12N
13
Nut for Bowl Insert
NUT4BOWLSSS
14
Washer for Bowl Insert
WASS14022
15
Bowl Insert
BOWLINSSL
16
*Air Tray Assembly
*NO CODE
17
Element
ELBW03000
18
*Tank Assembly
*NO CODE
19
Bowl
MWBBOWL
20
Swivel Tap
MWBSWTAPS
21
*Lid
*NO CODE
22
Tap Adaptor & O Ring
MWBTAPFITT
MWBORING
23
Pull Handle
P6BOHANDL
24
Waste Fitting
MWBWASTE
25
*Top
*NO CODE
26
Waste Tube (630mm Length)
MWB24TUBE
27
½” Tube (1060mm Length)
MWB1/2TUBE
28
½” Tube (770mm Length)
MWB1/2TUBE
29
Wheel Bracket (RH)
MWBWHBRKT
30
Castor Wheel
MWBWHEEL
31
Wheel Bracket (LH)
MWBWHBRKT
32
*Body
*NO CODE
33
*Base
*NO CODE
34
Trim (440mm Length)
CARTBLACKTRIM
35
Foot Pump
MWBFOOTPUMP
36
Waste Bucket
MWBUCKET
37
Mains Lead
MLEAD25
38
Vacuum Tube
MWBVACTUBE
Loom
W1 (x2)
W2 (x2)
W17 (x2)

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 11 of 15
www.parry.co.uk
WARRANTY INFORMATION
Warranty Policy
The manufacturer’s warranty is only valid in the UK mainland. Northern
Ireland, Western Isles, Inner Hebrides and Islands are parts only warranty.
All service calls will be carried out between the hours of 8.00am –5.00pm
Monday to Friday only.
We accept no responsibility for delays in replacing or repairing the
equipment due to circumstances beyond our control.
Your warranty can be immediately invalid if the installation of the
equipment has not been carried out in accordance with the manufacturer’s
instructions. (See installation details). Also the misuse, alteration or
unauthorised repairs of the equipment will invalidate the warranty.
During the warranty period it is at Parry’s discretion to repair or replace the
equipment.
Warranty only applies if the equipment has been used in a professional
manner following the manufacturer’s instructions and maintenance guide
lines.
The warranty covers defects in the material and component failure only.
We are not liable for trading loss, loss of perishable items, water damage,
loss due to injury or fire damage.
Please be aware that the warranty starts from the date of purchase from
Parry and not the sale or installation date of the equipment.

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 12 of 15
www.parry.co.uk
Warranty Request
Please ensure you have referred to the manufacturers’ instructions before
placing a warranty call. Or contact our warranty department on 01332
875665 for technical assistance, ensure you obtain the model number
before calling.
Please ensure you have read the section not covered under warranty to
avoid any unnecessary warranty charges.
It is vital that all warranty requests be submitted to Parry via email to
[email protected]
It is at the discretion of PARRY whether to honour a service call which is
out of the warranty period.
Not Covered Under Warranty
• Fault due to poor maintenance.
• Resetting of equipment or circuit breakers.
• Abuse of the equipment
• Foil should never be used on racks
• Blockages e.g., drains, condensers, pumps etc.
• Lime scale related issues
• Installed incorrectly
• Access arranged for service call and engineer refused access or customer not
there.
• No faults with the machine.

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 13 of 15
www.parry.co.uk
• Setting up of equipment e.g., dishwasher detergents, levelling and setting up of
doors on a 6 burner cooker.
• Excessive carbon build up on griddle plates.
• Over use of lava rock on the chargrills. Parry recommends maximum of 2kg.
• Faulty electrics – e.g., customers plug socket, plug, wiring, junction box fault,
wrong fuse.
• Any damages caused by the customer.
• Lamps, glass, door gaskets, Perspex, baskets, knobs all perishable items are
not covered.
This appliance should be routinely serviced to prolong its lifetime. Parry
recommends that the appliance is serviced every 12 months by a Parry
authorised engineer. Failure to service your product within the initial 12 month
warranty period will cause the 24 month warranty to become void.

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 14 of 15
www.parry.co.uk
Disposal Information
This appliance is marked according to the European Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health which could
otherwise be caused by inappropriate waste handling of this product.
A symbol on the product, or on the documents accompanying the product,
indicates that this appliance may not be treated as household waste. Instead it
should be handed over to the applicable collection point for the recycling of
electrical and electronic equipment.
Disposal must be carried out in accordance with local environmental regulations
for waste disposal.
For more detailed information about treatment, recovery and recycling of this
product, please contact your local city office, your household waste disposal
service or the shop where you purchased the product.

INSTRUCTION REF: IN262
ISSUE No. 1
DATE 08.03.17
Page 15 of 15
www.parry.co.uk
Parry Catering recognises our obligations to the EU DIRECTIVE covering the
waste disposal of electrical and electronic equipment (WEEE) Parry Catering are
committed to this policy in order to help conserve the environment.
At the end of this units life you MUST dispose of it in an approved manner. You
MUST not discard the unit or place it in the refuse bin.
You have several options:
a) Take the unit to an approved WEEE scheme company, there will be one in
your area.
b) Take the unit to an approved waste disposal site; many sites are managed by
your local authority.
Contact the units manufacturer, importer or their agent; the contact details will be
on the unit.
There will probably be a charge for this service which will depend on the physical
size and location of the unit. You will be given a collection price for a curb side
collection based on commercial rates prevailing at the time.
It should be noted that the unit to be collected should be suitably packed and
sealed to prevent dangerous gases and fluids from escaping. The condition of
the unit must also be clean to comply with health and safety regulations.
Parry Catering Equipment (Midlands) Ltd,
Town End Road,
Draycott,
Derby,
England,
DE72 3PT