Philips RAR-MAR36 User manual

MOBILE RADIATION APRON WALL RACK
RAR-MAR36
Instructions
Tools required.
· Phillips Screwdriver
- Two people assembly required
· 3/16” Allen Wrench
· 3/8” socket or adjustable wrench
Instructions
Step
Description
Picture
1
Loosen all screws to ensure no obstructions are
within are within the cavities.
2
Place the base on a level floor with casters wheels
toward you and smooth beam facing outwards.
3
Place the plate onto the base and hand tighten
with bolts. Repeat process on the other remaining
base and plate.
3a
When installing the plate only work on the
bottom row, the outside holes. Leaving the
middle hole open
4
Place vertical support on top of the base. Hand
tighten all two additional bolts. This leaves the
middle hole empty. Repeat process on the other
remaining plate assembly and vertical support.

MOBILE RADIATION APRON WALL RACK
RAR-MAR36
Instructions
5
Attach the lower cross beam to the assembly. Use
1 bolt and 1 washer to fasten one cross beam to
the assembly. The location of the cross beam is in
between the two bolts already in the base.
6
Once the lower cross beam is attached, attach the
second assembly of parts to the other side of the
cross beam.
5
Slide the hangers onto the remaining cross beam.
Install the cross beam with the hanger. To install
take the remaining bolts and washers and place
them into the holes of the vertical beam.
6
To install take the remaining bolts and washers
and place them into the holes of the vertical
beam.