V1.00/2010-03/visu’l © Phonak AG/All rights reserved/page 1/3
Bluetooth Pairing Guide
SmartLink+
SmartLink+ can be connected to Bluetooth devices that support the
following profiles:
Headset (HS)
Handsfree (HF)
Advanced Audio Distribution Profile (A2DP)
Note:
When running Bluetooth, SmartLink+ depends on the Bluetooth
functionality of the cellphone or other Bluetooth device. However
Bluetooth is not always well implemented in such devices. Therefore if
SmartLink+'s Bluetooth functionality does not work as expected, please
start by contacting your Bluetooth device dealer.
Pairing with a cellphone
1. Turn on both your cellphone and SmartLink+.
Place these next to each other.
2. Turn on your cellphone's Bluetooth function.
To activate your phone's Bluetooth feature, browse through its main-
and sub-menus. Its Bluetooth settings could be found under «Options»,
«Tools», «Settings», «Connections», «Connectivity», «Applications»,
«Control Panel», «Setup», or any combination of these (e.g. «Menu» /
«Settings» / «Connectivity» / «Bluetooth»).
3. Set SmartLink+ in pairing mode
Initiate the pairing process with SmartLink+ by pressing and hold-
ing the green telephone button for 5 seconds, until the entire display
starts flashing. SmartLink+ will remain in pairing mode for one minute
or until pairing is completed.
4. Search for SmartLink+ with your cellphone
Choose to “add a new Bluetooth device” on your cellphone. The phone
will start searching for all Bluetooth enabled devices within range.
5. Finalize the pairing
When a list of available Bluetooth devices appears on your phone,
select SmartLink+ and when asked for the passcode or passkey enter
«0000» (four zeros).
Note: «0000» is the default code and can be changed by your
audiologist or hearing professional if required.
Your cellphone will now complete the pairing process. When the Smar-
tLink+ has been successfully paired with your cellphone, its
display will stop flashing.
6. Connect
In addition to being paired, which is done only once, the SmartLink+
and cellphone also need to be connected. This is done either
automatically or via the cellphone's menu. If not automatically con-
nected, in your phone's Bluetooth feature menu select «Paired device»,
or «My devices», highlight «SmartLink+» and select «Connect». Some
phones may ask which Bluetooth service you wish to enable. Select
«headset» and if available «stereo headphones». With some cellphones,
a headset icon will appear to indicate that SmartLink+ is connected.
If prompted to allow automatic reconnection, it is recommended to
do so. This way SmartLink+ and the phone will automatically
(re)connect whenever they are within range.
