PLAYGROUND IDEAS SWING MONSTER TRUCK FLAT User manual

SWING MONSTER TRUCK FLAT
Instructions Author: Socheata Kong
www.playgroundideas.org

x48 x1 x4
Hex Bolt Paint & BrushTruck Tire Car Tire
SpannerDrill Utility Knife Grinder
This step-by-step playground plan is offered for support, guidance
and advice only and should not be relied upon in place of profession-
al or expert advice. We make no representation or warranty of any
kind, express or implied, about the completeness, accuracy, reliability
or suitability with respect to the step-by-step playground plan Further, Playground Ideas make
no representation that this step-by-step playground plan adhere to any safety standards in
your country and therefore each project/playground built should be assessed on an individual
basis in order to ensure compliance with national safety standards in the applicable country.
To the maximum extent permitted by law, in no event will Playground Ideas be liable for any
loss or damage including without limitation, direct, indirect or consequential loss or damage,
loss of profits or loss of opportunity arising out of or in any way connected with the any person
acting or refraining from acting in reliance of the step-by-step playground plan or for failure to
comply with the national safety standards in the applicable country, whether based in contract,
tort (including negligence), strict liability or otherwise.
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivs 3.0
Unported License. This means if you use or feature this work in any website, publication,
presentation etc, you must clearly attribute/ credit the work to www.playgroundideas.org (but
not in any way that suggests that PlaygroundIDEAS endorses you or your use of the work). You
may not use this work for commercial purposes without explicit permission. You may not alter,
transform, or build upon this work but you may create and add new work to the Playground-
IDEAS design library to share. To view a copy of this license, visit: http://creativecommons.org/li-
censes/by-nc-nd/3.0/.
Please note: All measurements are indicative only. Measurements need to be adjusted according
to context, available materials, tools, and local construction methods.
www.playgroundideas.org

Cut through the tire tread. First, use a utility knife to cut the rubber of the tire tread until you reach the
steel wire. Next, use a thin metal blade grinder to cut through the steel wire. Then, cut the rest of the
rubber with the utility knife. Finally, use a thick grinder blade to smooth the surface. Run your finger
along the surface of the cut to make sure it is smooth.
Cut the sidewall off of one side of a large mining truck tire or tractor tire and cut off both sidewalls of
four car tires.
Water
x4
2.
x1
x4
1.
www.playgroundideas.org

Wrap the car tire tread around a
fabricated supporting structure or strong
tree branches and have the tire tread
overlap. Next, drill holes through the
overlapping tire tread near the pole or
tree branches. Then, attach the tire tread
together with bolts, nuts, and washers.
Place the end of the car tire treads
underneath the truck tire and drill holes
through the tire tread into the truck tire
sidewall and where the car tire treads and
truck tire tread touch. Then, attach the car
tire tread and truck tire together with
bolts, nuts, and washers.
4.
x16
x4
3.
x32
x4
www.playgroundideas.org

This element requires soft fall material and can overlap with other elements. Please refer to the
Playground Ideas Safety Handbook.
150cm / 5’
23cm
/ 9”
www.playgroundideas.org

If you like this Swing Monster Truck Flat, please check out these elements below
as well:
Swing Truck Tire
Hammock
Swing Tractor Flat
Maxi Hammock
Swing Tractor Flat
Maxi Hammock
Swing Monster
Truck Half
www.playgroundideas.org