PR Housewares CONCEPT HOUSWARES PR-40322 User manual

Wall Mounted Wood Pot Racks
Models PR-40322, PR-40326
and PR-49332
Page 1
Concept Housewares, A Division of PR Housewares, LLC
www.prhousewares.com Email: [e-mail]
Photo A - Fully Assembled
Photo B - Pan Hooks
Photo C - Pan Hooks
Photo E - Front facing screw
Photo D - Wall screws, plastic
anchors and plastic key
Assembly:
To install, you will need the following:
- Level, pencil and tape measure
- Phillips head screw driver and a standard or
at head screwdriver
- Hammer
- Electric drill and 5/16 drill bit
Parts:
- Main unit (See Photo – A)
- Pan hooks, PR-41208 (See Photo –B)
- Package of 2 wall brackets and at bar. (See Photo – C)
- Package of 4 wall screws and 4 plastic anchors and
plastic key (See Photo – D)
Please consult with your local hardware store if you have any
questions or concerns about the construction of your walls or
ceilings. ey can assist you in selecting the proper hardware
and procedures. e generic hardware provided will work for
most drywall applications. NOTE: these units are handmade,
slight variations can exist, always measure twice before
drilling.
Mounting Directions:
Undo the front facing screw on each bracket, (photo, E) insert
at bar and replace screws. Note it may be necessary to use
the at head screwdriver to hold back of screws while the
Phillips screwdriver is used on the front to tighten or loosen.
en with rough frame work constructed use as a guide for
installation. Measure carefully where you want to mount the
rack on the wall use a pencil to mark where the screws attach
to the wall.
Remove the unit and drill holes using a 5/16” drill bit. When
possible mount to a wall stud. Supplied anchors have a pull
rating of 20 lbs. or more each and a shear rating of 50 lbs. each.
Insert the anchors into the drilled holes. ey may need to be tapped
in gently with a hammer. Use the supplied key to expand the anchor
behind drywall. (See Photos F to J on next page for proper and
improper anchor install). Use supplied screws to attach.

Wall Mounted Wood Pot Racks
Models PR-40322, PR-40326
and PR-49332
Page 2
Concept Housewares, A Division of PR Housewares, LLC
www.prhousewares.com Email: [e-mail]
Photo F - Drill 5/16” diameter
(8mm) hole. Fold anchor in middle.
Photo G - Insert anchor in hole
and tap ush with wall.
Photo H - Insert key to pop anchor
open & lock behind hollow wall
(not necessary for thick or solid
walls). Do not force of hammer key.
Photo I - Place item over anchor. Insert screw and
tighten untill screw is ush with xture. Then, stop.
The anchors also wedge securely in thick or solid
walls, or in wood studs behind drywall.
Photo J - correct (top) and
incorrect (bottom).
Questions - Comments
Damaged ‐ Defective ‐ Missing Parts
Contact us rst, we will respond within 24 hours or less. Please provide our part number, your
order number, place of purchase, address and any other info so we may address your concerns
promptly.
[e-mail] or www.prhousewares.com
Thank you!
Returns are only accepted when returned in new condition and only with an RMA from the
seller.
Returns to: 501 I South Reino Rd. Ste 152. Newbury Park, CA 91320