Ram Mounts Tough-Tray User manual

Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
Parts Index
not to scale
rammount.com
1.800.497.7479
[email protected] RAM®Tough-Tray™ Locking Kit
Locate and remove screw on the tray housing supporting
the spring.
4
I
J
E
Pull the Main Tray Slide out and attach (E) flange using (J) screws and (I) nuts.
RAM®logo must face upright.
3
AG
FN
C
Slide (F), (N) and (C) onto rod as shown below.
2
A
G
Thread (G) nut onto (A) rod with 3/8” of the rod protruding.
1
E
Ax 1
Bx 1
F G
N
JKO
IH
L
M
Cx 1
P
x 1x 1
#8
x 2
#12
x 1
1/4”
x 1
#8-32 x 3/8”
x 1 x 1
1/4”-20
x 1
#8-32
x 4
#8-32
x 2
x 4
#8-32 x 1/2”
x 1
#8-32 x 1 1/2”
Continue on back

Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
rammount.com
1.800.497.7479
[email protected] RAM®Tough-Tray™ Locking Kit
Close Main Tray Slide slowly while feeding the end of Rod Assembly through (E) flange. Place (M) washer on the end and attach (P) RAM® Pin-Lock
Nob all the way. Secure the Rod Assembly with (O) washer and (K) screw through the smaller hole on the (B) tube.
K
O
P
9
B
Fully insert Threaded Rod Assembly from Step 2 into (B) tube.
Separate (F) wedges as needed.
8
Pull Tray Slide out and wedge as shown.
7
Use the washer that comes with the original tray and place over (L) screw.
Feed (B) tube with larger hole first through Main Tray Housing and slide over
(L) screw. Gently secure with nut (H).
B
H
L
6
Insert (L) screw in the opposite direction, align the
Tray Slide back into Tray Housing and pull the end of
the spring over screw.
L
5
RMR-INS-234-LK