9. Elecromagnetic Compatibility
Electromagnetic compatibility (EMC) is the ability of electronic equipment to
function properly together in the electronic environment.
CE Notice (Europe)
Tactivo meets the following technical standards:
• EN 301 489-1:2011 • EN 61000-4-2:2008
• EN 55022:2006 – A1:2007 • EN 61000-4-3:2006 – A1:2008
FCC Information (USA)
Tactivo for iPad mini (P/N SAA 133 1009) and Tactivo for iPad Air (P/N SAA 130 1000)
comply with Part 15 (Class B) of the FCC Rules . Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
CONTACT: Precise Biometrics AB, Scheelevagen 30, Lund, 220 07, Sweden.
Precise Biometrics Inc., 11951 Freedom Drive, Reston, VA 20190, USA.
7. Charging & Synchronizing
Your iPad mini and iPad Air can be charged through a wall outlet using an
AC adapter and micro USB cable without disconnecting your Tactivo from
the device.
Your iPad mini or iPad Air can be synchronized using Wi-Fi communication.
If you want to use a cable for synchronization, Tactivo needs to be
disconnected from your iPad mini or iPad Air rst.
Tactivo should be used exclusively with supported iPad models. Do not
connect it to any other device.
Do not bend or twist the micro USB cable while connected to Tactivo.
Only use approved iPad mini and iPad Air chargers.
Do not attempt to use the Lightning connector-based docking stations
without removing Tactivo from the device.
Never force a connector into a port. This might damage the product.
8. Apps for Tactivo
The use of apps for Tactivo is entirely at the user’s sole risk. Precise Biometrics
has no liability whatsoever and disclaims all responsibility for the usage of
apps for Tactivo.
